2003 FORD MUSTANG Workshop Manual

fuse boxdiagnostic menuservice interval resetlightwindowlights
Popular search:
battery capacityfuel pumptransmission fluidwarning lightsaudiotiming beltfuel reserve
Previous
Next
Load previous 8 pages

Page 537 of 4378

FORD MUSTANG 2003 Workshop Manual 5. Loosen the RH rear bleeder screw. Leave open until clear, bubble- free brake fluid flows, then tighten the RH rear bleeder screw and remove the rubber hose. 6. Continue bleeding the rear of the s

Page 538 of 4378

FORD MUSTANG 2003 Workshop Manual GENERAL PROCEDURES Hydraulic Leak Check 1. NOTE: Brake fluid is water soluble and it is possible that all evidence of fluid leakage has been washed off if the vehicle has been operated in the rain

Page 539 of 4378

FORD MUSTANG 2003 Workshop Manual GENERAL PROCEDURES Runout Check — Brake Disc and Hub CAUTION: The brake disc (1126) runout specification must be met to ensure correct brake performance without roughness complaints. CAUTION:

Page 540 of 4378

FORD MUSTANG 2003 Workshop Manual 7. If the total indicated runout exceeds the maximum specification, remove the brake disc. For additional information, refer to Section 206 - 03 for front or to Section 206 - 04 for rear. 8. Cle

Page 541 of 4378

FORD MUSTANG 2003 Workshop Manual 13. If the brake disc TIR is still out of specification, measure and record the thickness of the brake disc. If thickness is sufficient to machine the brake disc to the runout specification, go to St

Page 542 of 4378

FORD MUSTANG 2003 Workshop Manual SPECIFICATIONS SECTION 206- 03: Front Disc Brake 2003 Mustang Workshop Manual General Specifications Item Specification Disc brake lining wear limit 1.0 mm (0.040 in) Disc thickness (Mustang/Mu

Page 543 of 4378

FORD MUSTANG 2003 Workshop Manual DESCRIPTION AND OPERATION Front Disc Brake Front Disc Brake Components Disc Brake Caliper Components SECTION 206- 03: Front Disc Brake 2003 Mustang Workshop Manual Item Part Number Description

Page 544 of 4378

FORD MUSTANG 2003 Workshop Manual The front disc brake caliper (2B120): �zbolts to the front disc brake caliper anchor plate (2B292), which bolts to the front wheel spindle (3105). �z is a pin slider, dual piston design. The front
Load next 8 pages
Page:   < prev 1-10 ... 505-512 513-520 521-528 529-536 537-544 545-552 553-560 561-568 569-576 ... 4384 next >
oil resethorngas typecabin filterbrake padsfuse box
Popular search:
lug patternoil changesteering wheel adjustmentparking brakelightsseat adjustmentroof rack