2003 FORD MUSTANG Workshop Manual

wipersengineairbag offservice interval resetheaterdiagnostic menu
Popular search:
radiocruise controlheadrestheatingspare tireinflation pressurefuel tank removal
Previous
Next
Load previous 8 pages

Page 345 of 4378

FORD MUSTANG 2003 Workshop Manual 16. Using the special tool, install the new differential bearings. 17. Position the differential assembly, including the differential bearing cups and differential bearing shims, in the differential

Page 346 of 4378

FORD MUSTANG 2003 Workshop Manual �z If the runout does not exceed the specification, use the new differential bearings for assembly. �z If the runout exceeds the specification, install a new differential case. For additional infor

Page 347 of 4378

FORD MUSTANG 2003 Workshop Manual 4. Install a differential bearing shim on the left side. 5. CAUTION: Always install the bearing caps in their identical locations and positions. NOTE: Apply pressure toward the left side to make s

Page 348 of 4378

FORD MUSTANG 2003 Workshop Manual 7. Install the right side bearing cap and tighten the left side and right side bolts to specification. 8. Rotate the differential assembly several times to verify that the differential bearings have

Page 349 of 4378

FORD MUSTANG 2003 Workshop Manual Zero backlash 10. If a zero backlash condition occurs, remove the bearing caps and add 0.51 mm (0.020 inch) to the RH side and subtract 0.51 mm (0.020 inch) from the LH side to allow backlash indica

Page 350 of 4378

FORD MUSTANG 2003 Workshop Manual 12. Rotate the differential assembly several times to verify that the differential bearings seated correctly. 13. Measure the backlash. Refer to Measuring backlash in this procedure. Backlash not w

Page 351 of 4378

FORD MUSTANG 2003 Workshop Manual 16. Rotate the differential several times to verify that the differential bearings have seated correctly. 17. Using the special tools, recheck the backlash. �zIf backlash is within the specification

Page 352 of 4378

FORD MUSTANG 2003 Workshop Manual 20. Install the bearing caps and bolts. 21. Using the special tools, recheck the backlash. �zThe specification shown is the full allowable range. For the preferred range, refer to Specifications in
Load next 8 pages
Page:   < prev 1-10 ... 313-320 321-328 329-336 337-344 345-352 353-360 361-368 369-376 377-384 ... 4384 next >
key batteryradiatorwiper fluidfuel caplow oil pressureservice
Popular search:
auxiliary batteryoil capacitiesECO moderemove seatscoolant capacityheight adjustmentheating