2003 FORD MUSTANG Workshop Manual

bolt patternradiatortraction controlcoolant temperaturetrunkload capacity
Popular search:
interior lightsservice indicatorCD playerbrake lightauxiliary batterybatterymirror
Previous
Next
Load previous 8 pages

Page 961 of 4378

FORD MUSTANG 2003 Workshop Manual 13. Disconnect the electrical connector. 14. NOTE: Remove the fuel injection supply manifold and fuel injectors as an assembly. Remove the bolts and the fuel injection supply manifold. 15. NOTE:

Page 962 of 4378

FORD MUSTANG 2003 Workshop Manual 16. Remove and discard the intake manifold gaskets. Installation 1. NOTE: If the lower intake manifold is not secured within four minutes, the sealant must be removed and the sealing area cleaned

Page 963 of 4378

FORD MUSTANG 2003 Workshop Manual 2. Install the intake manifold gaskets. 3. NOTE: If the lower intake manifold is not secured within four minutes, the sealant must be removed and the sealing area cleaned with metal surface cleaner

Page 964 of 4378

FORD MUSTANG 2003 Workshop Manual 4. NOTE: Refer to the location note made during removal and make sure the bolts are installed in the correct location. Tighten the bolts in two stages in the sequence shown: �zStage 1: Tighten the

Page 965 of 4378

FORD MUSTANG 2003 Workshop Manual 6. Connect the electrical connector. 7. Connect the coolant hoses. 8. Connect the EGR tube. 9. Connect the EGR vacuum tube. 10. Lubricate the O- ring with water and install the heater hose. Kl

Page 966 of 4378

FORD MUSTANG 2003 Workshop Manual 11. Install the heater bypass tube. For additional information, refer to Section 303 - 03A . 12. Connect the IMRC electrical connector. 13. Position and connect the engine wire harness. Install th

Page 967 of 4378

FORD MUSTANG 2003 Workshop Manual 16. Install the upper intake manifold. For additional information, refer to Upper Intake Manifold in this section. 17. CAUTION: Correct cooling system bleeding is critical for correct engine cool

Page 968 of 4378

FORD MUSTANG 2003 Workshop Manual IN- VEHICLE REPAIR Valve Cover — LH Removal and Installation 1. Position the ignition wires (12281) aside. 2. Disconnect the positive crankcase ventilation (PCV) valve (6758). 3. Remove the ign
Load next 8 pages
Page:   < prev 1-10 ... 929-936 937-944 945-952 953-960 961-968 969-976 977-984 985-992 993-1000 ... 4384 next >
lengthhornfuel pressurebluetoothnavigationchild restraint
Popular search:
jump start terminalsbattery locationoctaneoil temperatureclutchfuel reservebolt pattern