2003 FORD MUSTANG Workshop Manual

service interval resetcoolant temperaturerefuellingfuelECO modefuel tank removal
Popular search:
alternator beltcenter consolefold seatstransmissionbrake lightoil pressureoil level
Previous
Next
Load previous 8 pages

Page 809 of 4378

FORD MUSTANG 2003 Workshop Manual 6. Install the lock lever actuators. 1. Lubricate the lock lever actuator with Ignition Lock Grease F0AZ-19584-A or equivalent meeting Ford specification ESA- M1C232-A. 2. Install the lock lever act

Page 810 of 4378

FORD MUSTANG 2003 Workshop Manual Install the lower bearing and sleeve. 9. CAUTION: Install the steering column bearing so that the inner race is visible when installed. NOTE: Use an appropriate bearing installer or socket. Inst

Page 811 of 4378

FORD MUSTANG 2003 Workshop Manual 10. CAUTION: Install the steering column bearing so that the inner race is visible when installed. Item Part Number Description 1 — Outer race 2 — Bearing (in the "UP" position) 3 — B

Page 812 of 4378

FORD MUSTANG 2003 Workshop Manual NOTE: Use an appropriate bearing installer or socket. Install the bearing in the lock cylinder housing. Item Part Number Description 1 — Bearing slot 2 3511 Lock cylinder housing 3 — O

Page 813 of 4378

FORD MUSTANG 2003 Workshop Manual 11. Position the shaft in the steering column lock cylinder housing. �zInstall the bearing tolerance ring on the steering column shaft. 12. Install the bearing sleeve. 13. Install the upper bearing

Page 814 of 4378

FORD MUSTANG 2003 Workshop Manual 14. Install the snap ring. 15. Install the tilt pivot screws loosely and position the actuator housing in a vise. �zLubricate the pivot screws with Ignition Lock Grease F0AZ-19584- A or equivalent

Page 815 of 4378

FORD MUSTANG 2003 Workshop Manual Install the lock cylinder housing. �zPosition the lock cylinder housing and the shaft assembly on the actuator housing. �z Make sure the upper and lower lock actuators are aligned. �z Install and c

Page 816 of 4378

FORD MUSTANG 2003 Workshop Manual 21. NOTE: The narrow section of the keyhole in the lock gear should be in the one oclock position. Install the lock gear. �zUse Ignition Lock Grease F0AZ-19584-A or equivalent meeting Ford specifi
Load next 8 pages
Page:   < prev 1-10 ... 777-784 785-792 793-800 801-808 809-816 817-824 825-832 833-840 841-848 ... 4384 next >
technical specificationschange languageMPGwiring diagramheatingremote control
Popular search:
audioclimate settingsresetroof rackdiagnostic menuair conditioninglug pattern