2003 FORD MUSTANG Workshop Manual

parking sensorslumbar supportengine oil capacitybrake rotorparking brakeCD player
Popular search:
oil additivestraction controloil changedoor lockchild lockchange key batterylanguage
Previous
Next
Load previous 8 pages

Page 289 of 4378

FORD MUSTANG 2003 Workshop Manual DESCRIPTION AND OPERATION Driveshaft NOTE: All driveshaft assemblies are balanced. If undercoating the vehicle, protect the driveshaft to prevent overspray of any undercoating material. The drive

Page 290 of 4378

FORD MUSTANG 2003 Workshop Manual wheels. �z Consists of two single- cardan universal joints, a driveshaft slip yoke, a welded tube assembly and a driveshaft centering socket yoke. �z The splined driveshaft slip yoke permits the dr

Page 291 of 4378

FORD MUSTANG 2003 Workshop Manual DESCRIPTION AND OPERATION Universal Joints The universal joints are: �zlubed- for-life design and require no lubrication. �z equipped with nylon thrust washers, located at each base of the bearing

Page 292 of 4378

FORD MUSTANG 2003 Workshop Manual Klj . 2 ba 22003 Mustang Workshop Manual 17. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_4464/S3B~us~en~ ...

Page 293 of 4378

FORD MUSTANG 2003 Workshop Manual REMOVAL AND INSTALLATION Driveshaft Removal and Installation 1. Raise and support the vehicle. For additional information, refer to Section 100 - 02 . 2. Carry out the following: 1. Place an in

Page 294 of 4378

FORD MUSTANG 2003 Workshop Manual Lower the rear end of the driveshaft to clear the rear axle housing. Pull the driveshaft rearward until the driveshaft slip yoke clears the transmission extension housing. �zPlace a paint index mark

Page 295 of 4378

FORD MUSTANG 2003 Workshop Manual REMOVAL AND INSTALLATION Driveshaft — Cobra Removal and Installation 1. Raise and support the vehicle. For additional information, refer to Section 100 - 02 . 2. NOTE: To aid disassembly and

Page 296 of 4378

FORD MUSTANG 2003 Workshop Manual 2. Remove the four bolts. 6. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its components to disconnect t
Load next 8 pages
Page:   < prev 1-10 ... 257-264 265-272 273-280 281-288 289-296 297-304 305-312 313-320 321-328 ... 4384 next >
maintenance resetsensorsteering wheelOBD portbrake padstire size
Popular search:
wiringpower steeringremove seatsopen hoodoil changelightsCD changer