2003 FORD MUSTANG Workshop Manual

coolantstop starttailgatecoolant levelcruise controltrunk
Popular search:
octaneseat memoryheadlightskey fobad bluecoolant levelservice
Previous
Next
Load previous 8 pages

Page 977 of 4378

FORD MUSTANG 2003 Workshop Manual 1. NOTE: Lubricate the crankshaft front seal with clean engine oil before assembly. Using the special tool, install the crankshaft front seal. 2. Install the crankshaft pulley. For additional infor

Page 978 of 4378

FORD MUSTANG 2003 Workshop Manual IN- VEHICLE REPAIR Engine Front Cover Removal 1. Disconnect the battery ground cable. For additional information, refer to Section 414 - 01 . 2. Drain the engine cooling system. For additional i

Page 979 of 4378

FORD MUSTANG 2003 Workshop Manual 7. Disconnect the upper radiator hose and the bypass hose. 8. Remove the camshaft position (CMP) sensor. 9. Remove the heater water outlet tube. For additional information, refer to Section 303 - 0

Page 980 of 4378

FORD MUSTANG 2003 Workshop Manual 12. Disconnect the crankshaft position sensor electrical connector. 13. Remove the wiring harness pin- type retainer. 14. Remove the oil filter. 15. Remove the retainers and the water pump. Klj

Page 981 of 4378

FORD MUSTANG 2003 Workshop Manual 16. CAUTION: The cap screw is hidden; make sure to remove it or the engine front cover will be damaged. NOTE: Record the location, type and size of the fasteners. Remove the engine front cover.

Page 982 of 4378

FORD MUSTANG 2003 Workshop Manual 2. NOTE: If the engine front cover is not secured within four minutes, the sealant must be removed and the sealing area cleaned with metal surface cleaner. Allow to dry until there is no sign of we

Page 983 of 4378

FORD MUSTANG 2003 Workshop Manual 6. NOTE: The number 12 bolt is not part of the tightening sequence. Tighten the fasteners to 26 Nm (19 lb- ft) in the sequence shown. 7. Install a new oil filter. 8. Install the wiring harness pin

Page 984 of 4378

FORD MUSTANG 2003 Workshop Manual 9. Connect the crankshaft position sensor electrical connector. 10. Connect the lower radiator hose. 11. Install the camshaft synchronizer assembly. For additional information, refer to Section 303
Load next 8 pages
Page:   < prev 1-10 ... 945-952 953-960 961-968 969-976 977-984 985-992 993-1000 1001-1008 1009-1016 ... 4384 next >
batteryautomatic transmission fluidhandbrakeroofpairing phonetrunk release
Popular search:
dimensionschild seatground clearancedrain boltwiringtiresair bleeding