2003 FORD MUSTANG Workshop Manual

fuel filter locationtransmissionheadrestservice interval resetjump startglove box
Popular search:
torquewiper bladesmanual radio setfuel reserveset clockspark plugswidth
Previous
Next
Load previous 8 pages

Page 801 of 4378

FORD MUSTANG 2003 Workshop Manual DISASSEMBLY AND ASSEMBLY Steering Column Disassembly 1. WARNING: To avoid risk of serious personal injury, follow all warnings, cautions, notes and instructions in the driver air bag removal and

Page 802 of 4378

FORD MUSTANG 2003 Workshop Manual 4. Remove the lock housing bearing (3E700). 5. Remove the lock gear (3E717). 6. Remove the sensor ring. 1. Remove the lower bearing spring. 2. Remove the sensor ring. 7. Remove the lower bearing

Page 803 of 4378

FORD MUSTANG 2003 Workshop Manual 8. Remove the two tilt pivot screws. 9. WARNING: Steering column position spring is under tension and can come out with great force. Remove the lock cylinder housing and shaft assembly from the ac

Page 804 of 4378

FORD MUSTANG 2003 Workshop Manual 11. Remove the snap ring. 12. Remove the upper bearing spring (3520). 13. Remove the bearing sleeve (3518). 14. Remove the lower bearing tolerance ring (3L539). 1. Slide the steering column shaft

Page 805 of 4378

FORD MUSTANG 2003 Workshop Manual 15. Using a suitable punch, remove the lower bearing (3517) from the lock cylinder housing. 16. Use a suitable punch to remove the bearing from the lock cylinder housing. 17. Remove the lower bearin

Page 806 of 4378

FORD MUSTANG 2003 Workshop Manual 20. Remove the ignition lock cylinder lockout lever. 21. Remove the lock actuator lever return spring. 22. Using a pin punch, remove the pin and lock actuator lever. 23. Using a pin punch, remove t

Page 807 of 4378

FORD MUSTANG 2003 Workshop Manual 24. NOTE: Do not remove the tilt lock levers if not required. Using a pin punch, remove the pin, tilt locking levers and springs. Assembly 1. Install the locking lever cam and pin. 2. Install the

Page 808 of 4378

FORD MUSTANG 2003 Workshop Manual 3. Install the lock actuator lever return spring. 4. Install the ignition lock cylinder lockout lever. 5. NOTE: The lock lever with two teeth is installed on the left- hand side. If necessary, ins
Load next 8 pages
Page:   < prev 1-10 ... 769-776 777-784 785-792 793-800 801-808 809-816 817-824 825-832 833-840 ... 4384 next >
power steeringlane assisttorquewiper fluidESPspare tire location
Popular search:
high beamlug patterntire pressureair filterjump startchange key batterytailgate