2003 FORD MUSTANG Workshop Manual

stop startkeylessmirror controlsTPMS resetservice scheduledead battery open trunk
Popular search:
spark plugs replacefuel cap releaseinterior lightsair conditionchild restraintoil capacitieshood open
Previous
Next
Load previous 8 pages

Page 953 of 4378

FORD MUSTANG 2003 Workshop Manual 11. Disconnect the following: �zIgnition coil electrical connector. �z Radio interference capacitor electrical connector. �z Spark plug wires. 12. Disconnect the vacuum hose. 13. NOTE: For ease

Page 954 of 4378

FORD MUSTANG 2003 Workshop Manual 14. Remove and discard the upper intake manifold gasket. Installation 1. Install a new upper intake manifold gasket. 2. NOTE: Refer to the location note made during removal and make sure the bolts

Page 955 of 4378

FORD MUSTANG 2003 Workshop Manual �z Stage 1: Tighten to 10 Nm (89 lb- in). �z Stage 2: Rotate an additional 90 degrees (1/4 turn). 3. Connect the vacuum hose. 4. Connect the following: �zIgnition coil electrical connector. �z Ra

Page 956 of 4378

FORD MUSTANG 2003 Workshop Manual 5. Connect the vacuum hoses. 6. Connect the PCV tube. 7. Connect the differential pressure feedback EGR system electrical and vacuum connections. 8. Connect the EGR vacuum regulator solenoid electr

Page 957 of 4378

FORD MUSTANG 2003 Workshop Manual 9. Position the accelerator cable bracket and install the bolts. 10. Connect the accelerator and speed control cables to the throttle body cam. 11. Connect the EVAP return tube and the TP sensor ele

Page 958 of 4378

FORD MUSTANG 2003 Workshop Manual 13. Install the engine air cleaner outlet pipe. For additional information, refer to Section 303 - 12 . 14. Connect the battery ground cable. For additional information, refer to Section 414 - 01

Page 959 of 4378

FORD MUSTANG 2003 Workshop Manual IN- VEHICLE REPAIR Lower Intake Manifold Removal 1. Remove the upper intake manifold. For additional information, refer to Upper Intake Manifold in this section. 2. Partially drain the cooling

Page 960 of 4378

FORD MUSTANG 2003 Workshop Manual 8. Remove the heater bypass tube. For additional information, refer to Section 303 - 03A . 9. Disconnect the heater hose. 10. Disconnect the exhaust gas recirculation (EGR) vacuum tube. 11. Disco
Load next 8 pages
Page:   < prev 1-10 ... 921-928 929-936 937-944 945-952 953-960 961-968 969-976 977-984 985-992 ... 4384 next >
coolant reservoiroil levelparking sensorswiringbolt patternkeyless
Popular search:
timingbattery capacityfuel filter locationradio controlsphonecoolantengine oil capacity