2003 FORD MUSTANG Workshop Manual

Page 993 of 4378

FORD MUSTANG 2003  Workshop Manual 1.
NOTE:  Lubricate the parts with clean engine oil. 
To install, reverse the removal procedure. Tighten the rocker arm bolts in two stages.  �zStage 1: Tighten to 5 Nm (44 lb- in). 
�z Stage 2: Tight

Page 994 of 4378

FORD MUSTANG 2003  Workshop Manual IN-
VEHICLE REPAIR 
Valve Tappets 
Removal   CAUTION: If removing more than one valve tappet, mark the components removed for 
correct location. 
1. Remove the lower intake manifold. For additional in

Page 995 of 4378

FORD MUSTANG 2003  Workshop Manual Klj .  2 ba
  22003 Mustang Workshop Manual
17. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_4464/S3B~us~en~ ...

Page 996 of 4378

FORD MUSTANG 2003  Workshop Manual IN-
VEHICLE REPAIR 
Camshaft 
Removal  1. Remove the valve tappets. For additional information, refer to  Valve Tappets  in this section. 
2. Remove the timing chain. For additional information, refer

Page 997 of 4378

FORD MUSTANG 2003  Workshop Manual 6. Remove the camshaft. 
1. Remove the bolts. 
2. Remove the camshaft thrust plate. 
3. Remove the spacer. 
4. Remove the camshaft. 
Installation  1. NOTE:  Lubricate the camshaft with clean engine oi

Page 998 of 4378

FORD MUSTANG 2003  Workshop Manual Klj .  3 ba
  32003 Mustang Workshop Manual
17. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_4464/S3B~us~en~ ...

Page 999 of 4378

FORD MUSTANG 2003  Workshop Manual IN-
VEHICLE REPAIR 
Engine Dynamic Balance Shaft 
Removal  1. Remove the timing chain (6268). For additional information, refer to  Timing Chain  in this 
section. 
2. Disconnect and position the wire

Page 1000 of 4378

FORD MUSTANG 2003  Workshop Manual 1. Turn the camshaft so that the timing mark is at 12 oclock and install the engine dynamic 
balance shaft assembly into the cylinder block (6010). Turn the engine balance shaft driven 
gear so that