2003 FORD MUSTANG Workshop Manual

driver seat adjustmentmaintenance schedulenavigation updatewheel sizeengine overheatcheck engine light
Popular search:
wiper bladeswheel sizedisplaykeylesswindshield wipersoil changewasher fluid
Previous
Next
Load previous 8 pages

Page 385 of 4378

FORD MUSTANG 2003 Workshop Manual 6. Remove the outer differential pinion bearing. 7. Remove and discard the collapsible spacer (4662). 8. Using the special tool and a suitable press, remove the inner differential pinion bearing (46

Page 386 of 4378

FORD MUSTANG 2003 Workshop Manual 10. Using the special tools, remove the inner rear axle pinion bearing cup (4628). Installation Using special tool 205- 024 NOTE: This is the preferred method for installing the pinion bearing cup

Page 387 of 4378

FORD MUSTANG 2003 Workshop Manual the cup, remove and reseat the cup. Check that the cups have seated correctly in their bores. Using special tools 205- 153, -024, -231, and -D055 NOTE: This is an alternate method for installing t

Page 388 of 4378

FORD MUSTANG 2003 Workshop Manual Setting pinion depth 7. NOTE: Apply only a light oil film on the differential pinion bearings before assembling the tools. Assemble and position the following in the differential housing. 8. NOTE:

Page 389 of 4378

FORD MUSTANG 2003 Workshop Manual Tighten the special tool to specification. 9. NOTE: Offset the special tool to obtain an accurate reading. Rotate the special tool several half- turns to make sure the differential pinion bearings

Page 390 of 4378

FORD MUSTANG 2003 Workshop Manual 12. Position the correct thickness drive pinion bearing adjustment shim and the differential pinion bearing on the drive pinion gear. Using a suitable press and the special tools, press the differen

Page 391 of 4378

FORD MUSTANG 2003 Workshop Manual 16. Install the drive pinion assembly (drive pinion, shims, bearing, and the collapsible spacer) into the differential housing bore. 17. NOTE: Coat the rear axle drive pinion seal lips with Premium

Page 392 of 4378

FORD MUSTANG 2003 Workshop Manual 19. Lubricate the pinion flange splines. �zUse SAE 75W- 140 High Performance Rear Axle Lubricant F1TZ-19580- B or equivalent meeting Ford specification WSL- M2C192-A. 20. NOTE: Disregard the index
Load next 8 pages
Page:   < prev 1-10 ... 353-360 361-368 369-376 377-384 385-392 393-400 401-408 409-416 417-424 ... 4384 next >
buttonschange key batterywheel alignmentfuel consumptionkeyfuel filter location
Popular search:
OBD portcatalytic converterclocksteering wheelseat adjustmentjackingweight