2004 MITSUBISHI ENDEAVOR Service Repair Manual

Page 2769 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Check to see that the resistance shown in the graph is almost satisfied when 
measuring the resistance between terminal 1 and 3 of the door mirror (RH) 
connector 
E-01. 
cold), leave the car in the l

Page 2770 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual  
2004 Mitsubishi Endeavor LS 
2004 BODY & ACCESSORIES Door Mirror - Endeavor

Page 2771 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Fig. 26: Identifying Connector E 
-01 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA. 
Q: Is the measured value within the range in the graph?  
YES: Go to Step 10.  
NO: Replace the door mirror (RH).

Page 2772 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Fig. 27: Identifying Connector E 
-01 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA. 
2. Measure the resistance value between terminal 3 and ground. 
The resistance should equal 2 ohms or less. 
Fig.

Page 2773 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual (RH) connector E-01 (terminal 3) and ground
. 
Fig. 29: Identifying Connector E 
- 01 
 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA. 
NOTE: Also check intermediate connector C-13 for loose, 
corrod

Page 2774 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Fig. 30: Identifying Connector C 
- 13
 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA. 
Q: Is the wiring harness between remote controlled mirror (RH) 
connector E-01 (terminal 3) and ground in good

Page 2775 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Fig. 31: Identifying Connector C 
- 104
 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA. 
Q: Is joint connector (2) C-104 in good condition?  
YES: Go to Step 13 .  
NO: Repair or replace the damaged

Page 2776 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Fig. 32: Identifying Connector E 
- 01
 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 
2004 Mitsubishi Endeavor LS 
2004 BODY & ACCESSORIES Door Mirror - Endeavor