2004 MITSUBISHI ENDEAVOR Service Repair Manual

Page 1833 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual NO: Replace the DIN cable.  
STEP 8. Measure the resistance value at rear display connector D-36. 
1. Disconnect the connector, and measure at the wiring harness side. 
Fig. 8: Identifying D
-36 Conne

Page 1834 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Fig. 9: Measuring The Resistance Value At Rear Display Connector D-36 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA. 
Q: Is the check result normal?  
YES: Go to Step 10 .  
NO: Go to Step 9.  
STEP

Page 1835 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Fig. 10: Checking The Wiring Harness Between Rear Display Connector D
-36 Terminal No 2
 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA. 
Q: Is the check result normal?  
YES: Retest the system.  
NO:

Page 1836 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual NO: If the system is operated via the main panel, replace the rear display 
unit assembly (overhead type). If the system is operated via the remote 
control, refer to INSPECTION PROCEDURE 4: THE REMOT

Page 1837 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Substitute the rear display unit assembly (overhead type), and check that the 
disc sound is played. 
Q: Is the check result normal?  
YES: If the system is operated via the main panel, replace the re

Page 1838 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual NO: Confirm the disc face, and insert it again. (If the disc is single-sided, 
its label should face up)  
STEP 3. Confirm the disk. 
Confirm that the disk is not contaminated or scratched. 
Q: Is the

Page 1839 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Check the disk is being played in a normal mode without using special 
functions such as rewinding, fast-forwarding, slow motion or pause. 
Q: Is the check result normal?  
YES: Go to Step 8.  
NO: Ch

Page 1840 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Q: Is the check result normal?  
YES: Replace the M-bus adapter.  
NO: Check the wiring harnesses and the DIN cable between each speakers 
and the M-bus adapter, and repair or replace if necessary. Th