2004 MITSUBISHI ENDEAVOR Service Repair Manual

jump start terminals sunroof rear entertainment change time wheel bolts oil reset

Load previous 8 pages

Page 3729 of 3870

MITSUBISHI ENDEAVOR 2004 Service Repair Manual >>A<< REAR WIPER ARM AND BLADE ASSEMBLY INSTALLATIONBefore installing the rear wiper arm and blade assembly, operate the rear wiper
motor so that the motor stops at the predetermined park position. I

Page 3730 of 3870

MITSUBISHI ENDEAVOR 2004 Service Repair Manual Fig. 10: Installing Wiper Blase Rubber & Blade Assembly

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
INSPECTION REAR WASHER MOTOR CHECK 1. Remove the rear washer tank assembly with the washer hos

Page 3731 of 3870

MITSUBISHI ENDEAVOR 2004 Service Repair Manual Fig. 11: Checking Rear Washer Motor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor

Page 3732 of 3870

MITSUBISHI ENDEAVOR 2004 Service Repair Manual 2. Check to see that the water is vigorously sprayed when connecting the positive
battery terminal to terminal number 2 and terminal number 1 to the ground. REAR WIPER AND WASHER SWITCH CHECK Check

Page 3733 of 3870

MITSUBISHI ENDEAVOR 2004 Service Repair Manual Courtes
y of MITSUBISHI MOTOR SALES OF AMERICA
.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor

Page 3734 of 3870

MITSUBISHI ENDEAVOR 2004 Service Repair Manual 2004 BODY & ACCESSORIES
Windshield Wiper And Washer - Endeavor
GENERAL DESCRIPTION WINDSHIELD WIPER AND WASHER OPERATION WINDSHIELD LOW-SPEED (AND HIGH-SPEED) WIPER OPERATION
If the windshield low-

Page 3735 of 3870

MITSUBISHI ENDEAVOR 2004 Service Repair Manual If the windshield mist wiper switch is turned to the ON position, with the
ignition switch at the "ACC" or "ON" position, the mist wiper high-speed
operation signal is sent to the fr

If the windshield mist wiper switch is turned to the ON position, with the
ignition switch at the "ACC" or "ON" position, the mist wiper high-speed
operation signal is sent to the front-ECU. This signal turns on the wiper speed
control relay, causing the wipers to work at high-speed while the mist switch is
on. While the windshield mist wiper switch remains turned on when the
intermittent mode is still working, the wipers work as the mist wiper. However,
the wipers return to the intermittent mode again when the switch is changed
back to "INT" position. To prevent the windshield mist wiper from operating when the windshield
wiper switch is turned OFF, the windshield mist wiper does not work for 0.5
second after the windshield intermittent wiper switch, the windshield low-
speed wiper switch and the windshield high-speed wiper switch are turned
OFF.
WINDSHIELD WASHER OPERATION
If the windshield washer switch is turned to the ON position with the ignition
switch at "ACC" or "ON" position, the windshield washer ON signal is sent to
the front-ECU. After 0.3 second, the windshield wiper signal turns on. After
the windshield washer switch signal turns off, the windshield wiper signal
turns off in three seconds. If the windshield washer switch is turned on while the windshield wiper is at
intermittent mode, and the windshield washer switch is turned OFF within 0.2
second, the wiper works only once to perform mist operation. When the
windshield washer switch is turned on for more than 0.2 second, the wiper
performs the same movement as normal condition from the time when 0.2
second has elapsed, and then returns to intermittent operation.
WINDSHIELD WIPER AND WASHER DIAGNOSIS The windshield wiper and washer are controlled by the Simplified Wiring System
(SWS). For troubleshooting, refer to SWS DIAGNOSIS
.
NOTE: Even when the ETACS-ECU has failed, the windshield wiper
can work at low speed in fail-safe mode. (Normally, the

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Windshield Wiper And Washer - Endeavor

Page 3736 of 3870

MITSUBISHI ENDEAVOR 2004 Service Repair Manual ON-VEHICLE SERVICE WINDSHIELD INTERMITTENT WIPER VOLUME CHECK 1. If the windshield intermittent wiper volume is operated, the wiper interval
should change.
2. Holding the windshield intermittent wi

Load next 8 pages

Page: < prev 1-10 ... 3697-3704 3705-3712 3713-3720 3721-3728 3729-3736 3737-3744 3745-3752 3753-3760 3761-3768 ... 3872 next >

load capacity spare tire location fuel pump fuse box diagram check engine light ground clearance