2004 MITSUBISHI ENDEAVOR washer fluid

5. If the run-out cannot be corrected by changing the phase of the brake disc,
replace the brake disc or grind it with the on-the-car type brake lathe ("MAD,
DL-8700PF" or equivalent). MASTER CYLINDER FUNCTION CHECK 1. Remove the reservoir cap.
2. While watching the open reservoir from a distance of 50 cm (20 inches), have
an assistant depress the brake pedal. If there was a stream of brake fluid rising
from the reservoir, proceed to Step 3. If there was no stream of brake fluid
rising from the reservoir, repair or replace the master cylinder.
3. While watching the open reservoir from a distance of 50 cm (20 inches), have
the assistant release the brake pedal. If there was a small amount of air bubbles
rising through the brake fluid, master cylinder function is normal. If there were
no bubbles rising through the brake fluid, repair or replace the master cylinder. BRAKE PEDAL REMOVAL AND INSTALLATION
Fig. 42: Identifying M12 Flat Washer

Courtes
y of MITSUBISHI MOTOR SALES OF
A
Grind the brake disc with all wheel nuts dia
gon
equall
y tightened to the specified torque 100
N
lb). When all numbers of wheel nuts are not u
s
the ti
ghtenin
g torque is excessive or not equa
brake disc rotor or drum ma
y be deformed, re
s
judder.

2004 Mitsubishi Endeavor LS
2004 BRAKES Basic Brake System - Endeavor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA
.
REAR WASHER FLUID EJECTION CHECK If the rear washer does not spray washer fluid within the area shown, adjust it by
moving it.
Fig. 7: Checking Washer Fluid Ejection

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
REAR WIPER AND WASHER REMOVAL AND INSTALLATION
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor

ON-VEHICLE SERVICE WINDSHIELD INTERMITTENT WIPER VOLUME CHECK 1. If the windshield intermittent wiper volume is operated, the wiper interval
should change.
2. Holding the windshield intermittent wiper volume, input the simulated vehicle
speed with scan tool MB991958 and check that the wiper interval changes as
the vehicle speed changes.
3. If not, carry out the troubleshooting (Refer to SWS DIAGNOSIS
).
WINDSHIELD WASHER FLUID EJECTION CHECK The windshield washer nozzle aiming can not be adjusted. If the washer nozzles do
not spray washer fluid within the swept area, check the nozzles as follows.
1. Check that the windshield washer nozzles are fitted on the hood correctly, and
reinstall them if necessary. windshield wiper operates when the ignition switch is at the
"ACC" or "ON" position. But, if it enters the fail-safe mode,
the wiper can operate only when the ignition switch is at the
"ON" position).
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Windshield Wiper And Washer - Endeavor