Page 1273 of 5883
DLK-684
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
SUPER LOCK ACTUATOR
2. Check continuity between BCM connector (A) M20 terminals 67,
75 and ground.
Is the inspection result normal?
YES >> Replace BCM. Refer to XX-XX, "*****".
NO >> Repair or replace harness.
BCM connector Terminals Continuity
M2067
Ground No
75
ALKIA0827ZZ
Page 1274 of 5883
![NISSAN TIIDA 2007 Service Repair Manual TRUNK LID OPENER ACTUATOR
DLK-685
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
MA
B
DLK
N
O
P
TRUNK LID OPENER ACTUATOR
DescriptionINFOID:0000000001530813
Performs trunk l NISSAN TIIDA 2007 Service Repair Manual TRUNK LID OPENER ACTUATOR
DLK-685
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
MA
B
DLK
N
O
P
TRUNK LID OPENER ACTUATOR
DescriptionINFOID:0000000001530813
Performs trunk l](/manual-img/5/57395/w960_57395-1273.png)
TRUNK LID OPENER ACTUATOR
DLK-685
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
MA
B
DLK
N
O
P
TRUNK LID OPENER ACTUATOR
DescriptionINFOID:0000000001530813
Performs trunk lid open with signal from BCM.
Component Function CheckINFOID:0000000001530814
1.CHECK FUNCTION
1. Perform Active Test TRUNK/GLASS HATCH with CONSULT-III.
2. Touch “OPEN” and check that trunk lid opens.
Is the inspection result normal?
YES >> Trunk lid opener actuator is OK.
NO >> Refer to DLK-685, "
Diagnosis Procedure".
Diagnosis ProcedureINFOID:0000000001530815
1.CHECK OUTPUT SIGNAL
1. Turn ignition switch OFF.
2. Ensure door lock system is unlocked.
3. Check voltage between BCM connector and ground.
Is the inspection result normal?
YES >> GO TO 3
NO >> GO TO 2
2.CHECK TRUNK LID OPENER ACTUATOR CIRCUIT
1. Disconnect BCM and trunk lamp switch and trunk release solenoid connectors.
2. Check continuity between BCM connector (A) M20 terminal 68
and trunk lamp switch and trunk release solenoid connector (B)
B66 terminal 2.
ALKIA0765ZZ
Te r m i n a l s
Condition of trunk lid open-
er switchVoltage (V)
(Approx.) (+)
(–)
BCM connector Terminal
M20 68 Ground ON 0 → Battery voltage → 0
ALKIA0766ZZ
Page 1275 of 5883
![NISSAN TIIDA 2007 Service Repair Manual DLK-686
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
TRUNK LID OPENER ACTUATOR
3. Check continuity between BCM connector (A) M20 terminal 68 and ground.
Is the inspection result normal?
YES NISSAN TIIDA 2007 Service Repair Manual DLK-686
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
TRUNK LID OPENER ACTUATOR
3. Check continuity between BCM connector (A) M20 terminal 68 and ground.
Is the inspection result normal?
YES](/manual-img/5/57395/w960_57395-1274.png)
DLK-686
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
TRUNK LID OPENER ACTUATOR
3. Check continuity between BCM connector (A) M20 terminal 68 and ground.
Is the inspection result normal?
YES >> Refer to DLK-686, "Component Inspection".
NO >> Repair or replace harness.
3.CHECK TRUNK LID OPENER ACTUATOR GROUND CIRCUIT
Check continuity between trunk lamp switch and trunk release sole-
noid connector and ground.
Is the inspection result normal?
YES >> GO TO 4
NO >> Repair or replace trunk lamp switch and trunk release solenoid ground circuit.
4.CHECK INTERMITTENT INCIDENT
Refer to XX-XX, "*****"
.
>> INSPECTION END.
Component InspectionINFOID:0000000001530816
1.CHECK TRUNK LAMP SWITCH
Momentarilly, connect battery power supply to trunk lamp switch and
trunk release solenoid terminals and check for solenoid operation.
BCM connector Terminaltrunk lamp switch and trunk re-
lease solenoid connectorTerminal Continuity
M20 68 B66 2 Yes
BCM connector Terminal Continuity
M20 68 Ground No
ALKIA0763ZZ
Trunk lamp switch and trunk release
solenoid connectorTe r m i n a l
GroundContinuity
B66 1 Yes
ALKIA0767ZZ
Page 1276 of 5883
TRUNK LID OPENER ACTUATOR
DLK-687
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
MA
B
DLK
N
O
P
Is the inspection result normal?
YES >> INSPECTION END.
NO >> Replace trunk lamp switch and trunk release solenoid.
Te r m i n a l
Trunk condition
Trunk lamp switch and trunk release solenoid
1 BAT (-) 2 BAT (+) Solenoid operates
Page 1277 of 5883
DLK-688
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
BUZZER (COMBINATION METER)
BUZZER (COMBINATION METER)
DescriptionINFOID:0000000001397313
Performs operation method guide and warning with buzzer.
Component Function CheckINFOID:0000000001397314
1.CHECK FUNCTION
With CONSULT-III
Check the operation with “INSIDE BUZZER” in “Active Test”.
Is the inspection result normal?
Yes >> Warning buzzer in combination meter is OK.
No >> Refer to DLK-688, "
Diagnosis Procedure".
Diagnosis ProcedureINFOID:0000000001397315
1.CHECK BUZZER (COMBINATION METER) CIRCUIT
Refer to XX-XX, "*****"
.
Is the inspection result normal?
Ye s > > G O T O 2 .
No >> Repair or replace buzzer (combination meter) circuit.
2.CHECK INTERMITTENT INCIDENT
Refer to @@@.
>> INSPECTION END
Test item Condition
INSIDE BUZZER:TAKE OUT Take away warning chime sounds
:KNOB Ignition knob switch warning chime sounds
:KEY Key warning chime sounds
Page 1278 of 5883
HAZARD WARNING LAMPS
DLK-689
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
MA
B
DLK
N
O
P
HAZARD WARNING LAMPS
DescriptionINFOID:0000000001397316
Performs answer-back for each operation with the number of blinks.
Component Function CheckINFOID:0000000001397317
1.CHECK FUNCTION
With CONSULT-III
Check hazard warning lamp “FLASHER” in “Active Test” mode.
Is the inspection result normal?
YES >> Hazard warning lamp circuit is OK.
NO >> Refer to DLK-689, "
Diagnosis Procedure".
Diagnosis ProcedureINFOID:0000000001397318
1.CHECK HAZARD SWITCH CIRCUIT
Check hazard switch circuit.
Refer to XX-XX, "*****"
.
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace hazard warning switch circuit.
2.CHECK INTERMITTENT INCIDENT
Refer to @@@.
>> INSPECTION END
Page 1279 of 5883
DLK-690
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
VEHICLE SPEED SIGNAL CIRCUIT
VEHICLE SPEED SIGNAL CIRCUIT
DescriptionINFOID:0000000001397319
Displays the vehicle speed signal received from combination meter as a numerical value (km/h).
Component Function CheckINFOID:0000000001397320
1.CHECK FUNCTION
Check that all doors are automatically locked at the vehicle speed of more than 12 km/h (7 MPH).
Is the inspection result normal?
YES >> Vehicle speed signal circuit is OK.
NO >> Refer to DLK-690, "
Diagnosis Procedure".
Diagnosis ProcedureINFOID:0000000001397321
1.CHECK VEHICLE SPEED SIGNAL CIRCUIT
Check vehicle speed signal “VEHICLE SPEED” in “Data Monitor” mode.
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace vehicle speed signal circuit.
2.CHECK INTERMITTENT INCIDENT
Refer to @@@.
>> INSPECTION END
Page 1280 of 5883
![NISSAN TIIDA 2007 Service Repair Manual KEYFOB BATTERY AND FUNCTION
DLK-691
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
MA
B
DLK
N
O
P
KEYFOB BATTERY AND FUNCTION
DescriptionINFOID:0000000001530829
The followin NISSAN TIIDA 2007 Service Repair Manual KEYFOB BATTERY AND FUNCTION
DLK-691
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
MA
B
DLK
N
O
P
KEYFOB BATTERY AND FUNCTION
DescriptionINFOID:0000000001530829
The followin](/manual-img/5/57395/w960_57395-1279.png)
KEYFOB BATTERY AND FUNCTION
DLK-691
< COMPONENT DIAGNOSIS >[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
MA
B
DLK
N
O
P
KEYFOB BATTERY AND FUNCTION
DescriptionINFOID:0000000001530829
The following functions are available when having and carrying the keyfob.
Door lock/unlock
Back door unlock (hatchback)
Trunk lid unlock (sedan)
Remote control entry function is available when operating the remote buttons.
Component Function CheckINFOID:0000000001530830
1.CHECK FUNCTION
With CONSULT-III
Check BCM "RKE OPE COUN1" in DATA MONITOR mode with CONSULT-III.
Is the inspection result normal?
YES >> Keyfob is OK.
NO >> Refer to DLK-691, "
Diagnosis Procedure".
Diagnosis ProcedureINFOID:0000000001530831
1.CHECK KEYFOB FUNCTION
Do doors lock and unlock when using the keyfob buttons?
YES or NO?
YES >> Keyfob is OK.
NO >> GO TO 2.
2.CHECK KEYFOB BATTERY
Check by connecting a resistance (approximately 300Ω) so that the
current value becomes about 10 mA.
Is the measurement value within specification?
YES >> Key fob battery is OK.
NO >> Replace keyfob battery.
Component InspectionINFOID:0000000001530832
For battery removal and installation, refer to XX-XX, "*****".
Special Repair RequirementINFOID:0000000001530833
Refer to CONSULT-III Operation Manual.
Monitor item Condition
RKE OPE COUN1 Check that the numerical value is changing while operating the keyfob.
Standard : Approx. 2.5 - 3.0V
OCC0607D