Page 809 of 4264
ELECTRICAL-BODY AND CHASSIS 8A-151
CIRCUIT DIAGRAM (RHD)
RTW48AXF014001
Page 810 of 4264
8A-152 ELECTRICAL-BODY AND CHASSIS
CIRCUIT DIAGRAM (LHD)
RTW48XF014101
Page 811 of 4264
ELECTRICAL-BODY AND CHASSIS 8A-153
HEADLIGHT LEVELING SWITCH
Incorrect beam angle due to load change can be corrected.
A four position switch, 0-3, can alter the beam angle through
1.7 degrees on the long wheel base model and 2.17 degrees
on the short wheel base model.
825R300049
Inspection
Check to see if there is any continuity between the terminals of
the leveling switch.
Replace the switch when the result of inspection is found
abnormal.
Removal
Preparation:
Disconnect the battery ground cable.
1. Ventilation grille
2. Harness connector
3. Headlight leveling switch
To remove the switch, push the lock from the back side of
the cluster assembly.
Installation
To install, follow the removal steps in the reverse noting the
following point.
1. Push in the switch with your fingers until it locks securely.
Page 812 of 4264
8A-154 ELECTRICAL-BODY AND CHASSIS
ILLUMINATION
PARTS LOCATION (RHD)
RTW38DMF016201 & RTW38DMF016301
Page 813 of 4264
ELECTRICAL-BODY AND CHASSIS 8A-155
PARTS LOCATION (LHD)
RTW48AXF016401 & RTW48AXF016501
Page 814 of 4264
8A-156 ELECTRICAL-BODY AND CHASSIS
CIRCUIT DIAGRAM (RHD) G.EXP
RTW48AXF011901
Page 815 of 4264
ELECTRICAL-BODY AND CHASSIS 8A-157
CIRCUIT DIAGRAM (RHD) EUROPE
RTW48AXF012001
Page 816 of 4264
8A-158 ELECTRICAL-BODY AND CHASSIS
CIRCUIT DIAGRAM (LHD) G.EXP
RTW48AXF011801