2006 DODGE RAM SRT-10 Service Repair Manual

Page 377 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 3.(Z903) GROUND CIRCUIT OPEN
Turn the ignition off.
Using a 12-volt test light connected to the 12-volts, probe the (Z903)
Ground circuit in the MDS Solenoid No.6 harness connector.
Does the test ligh

Page 378 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 6.(K453) MDS SOLENOID NO.6 CONTROL CIRCUIT OPEN
CAUTION: Do not probe the PCM harness connectors. Probing the
PCM harness connectors will damage the PCM terminals resulting
in poor terminal to pin con

Page 379 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P3442–CYLINDER 6 DEACTIVATION CONTROL PERFORMANCE

Page 380 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual For a complete wiring diagramRefer to Section 8W.
Theory of Operation
When all criteria has been met, power is supplied to each MDS Solenoid when the engine is making a transition
from 8 cylinder mode

Page 381 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 3.(K453) MDS SOLENOID NO.6 CONTROL CIRCUIT SHORTED TO VOLTAGE
Turn the ignition off.
Disconnect the C2 PCM harness connector.
Turn the ignition on.
Measure the volage of the (K453) MDS Solenoid No.6 C

Page 382 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 5.OIL PASSAGES RESTRICTED
Turn the ignition off.
Remove both Solenoids on Bank 2 of the engine block.
Remove the Bank 2 Cylinder Head per Service Information.
Remove the Lifters from the left engine b

Page 383 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P3449-MDS SOLENOID 7 CIRCUIT

Page 384 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual For a complete wiring diagramRefer to Section 8W.
Theory of Operation
When all criteria has been met, power is supplied to each MDS Solenoid when the engine is making a transition
from 8 cylinder mode