2006 DODGE RAM SRT-10 Service Repair Manual

checking oil open bonnet glove box trip computer lumbar support key battery

Load previous 8 pages

Page 4537 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 3. Install the bolts (2) that secure the rear console (1)
to the floor panel.
4. Install the inserts.
5. Install the gear shift lever extension.
6. Install the 4WD gear shift boot.

Page 4538 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual Full Floor Console
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/SEATS - WARNING)
NOTE: Do not reuse the seat fasteners, always
repl

Page 4539 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual HEADLINER
REMOVAL
NOTE: Headliner for Quad Cab model shown. Reg-
ular cab similar.
1. Remove the A-pillar trim panels (Refer to 23 -
BODY/INTERIOR/A-PILLAR TRIM - REMOVAL).
2. Remove the upper B-pilla

HEADLINER
REMOVAL
NOTE: Headliner for Quad Cab model shown. Reg-
ular cab similar.
1. Remove the A-pillar trim panels (Refer to 23 -
BODY/INTERIOR/A-PILLAR TRIM - REMOVAL).
2. Remove the upper B-pillar trim panels (Refer to 23
- BODY/INTERIOR/B-PILLAR UPPER TRIM -
REMOVAL).
3. On Quad Cab models, remove the upper C-pillar
trim panels (Refer to 23 - BODY/INTERIOR/C-PIL-
LAR TRIM - REMOVAL).
4. Disconnect the wire harness connector (1) located
at the left A-pillar from the headliner wire harness
(2).
5. Disconnect the headliner wire harness connector
(3) from the inside rear view mirror.
6. Remove the overhead console (Refer to 8 - ELEC-
TRICAL/OVERHEAD CONSOLE - REMOVAL).
7. Remove the sun visors (4) (Refer to 23 - BODY/INTERIOR/SUN VISOR - REMOVAL).
8. Remove the sun visor supports (5) (Refer to 23 - BODY/INTERIOR/SUN VISORSUPPORT - REMOVAL).
9. Remove the dome lamp (6) (Refer to 8 -ELECTRICAL/LAMPS/LIGHTING - INTERIOR/DOME LAMP -
REMOVAL).
10. Remove the two coat hooks (7) (Refer to 23 - BODY/INTERIOR/COAT HOOK - REMOVAL).
11. Lower the rear of the headliner (9) downward from the roof panel (10) anddisconnect the headliner wire har-
ness connector (8) from the center high mounted stop lamp.
12. Lower the front of the headliner downward and remove the headliner through the passenger door opening.
INSTALLATION
NOTE: Headliner for Quad Cab model shown. Reg-
ular cab similar.
1. Position the headliner (9) into the vehicle through
the passenger door opening.
2. Connect the headliner wire harness connector (8)
to the center high mounted stop lamp.
3. Raise the rear of the headliner upward and install
the two coat hooks (7) (Refer to 23 - BODY/INTE-
RIOR/COAT HOOK - INSTALLATION).
4. Raise the front of the headliner upward and install
the sun visor supports (5) (Refer to 23 - BODY/IN-
TERIOR/SUN VISOR SUPPORT - INSTALLA-
TION).
5. Install the sun visors (4) (Refer to 23 - BODY/IN-
TERIOR/SUN VISOR - INSTALLATION).
6. Install the dome lamp (6) (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - INTERIOR/DOME LAMP
- INSTALLATION).
7. Install the overhead console (Refer to 8 - ELECTRICAL/OVERHEAD CONSOLE-INSTALLATION).
8. Connect the headliner wire harness connector (3) to the inside rear viewmirror

Page 4540 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 9. Connect the headliner wire harness (2) to the wire harness connector (1)located at the left A-pillar.
10. On Quad Cab models, install the upper C-pillar trim panel (Refer to 23 - BODY/INTERIOR/C-PI

Page 4541 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual LOAD FLOOR
REMOVAL
1. Move the rear seat cushion (1) to the up position.
2. Remove the two nuts (2) that secure the rear of the
load floor (3) to the floor panel.
3. Move the load floor (2) to the up

Page 4542 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual INSTALLATION
1. If removed, install the load floor support cylinder (4)
(Refer to 23 - BODY/INTERIOR/LOAD FLOOR
SUPPORT CYLINDER - INSTALLATION).
2. Position the load floor (2) into the vehicle and
in

Page 4543 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual REAR CAB BACK PANEL TRIM
REMOVAL
1. If equipped, remove the three bolts (1) that secure
the rear storage compartment (2) to the floor panel
(3) and remove the storage compartment from the
rear cab tri

Page 4544 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 3. On Regular cab models, remove the lower B-pillar
trim panels (Refer to 23 - BODY/INTERIOR/B-PIL-
LAR LOWER TRIM - REMOVAL).
4. On Regular cab models, remove the utility hook (3)
or the storage bin

Load next 8 pages

Page: < prev 1-10 ... 4505-4512 4513-4520 4521-4528 4529-4536 4537-4544 4545-4552 4553-4560 4561-4568 4569-4576 ... 5272 next >

headlight aiming suspension brake service low beam width