2006 DODGE RAM SRT-10 Service Repair Manual

open gas tankpower steeringpark assistbattery locationdead battery open trunkdisplay
Popular search:
start stop buttonservice resetwarningoil pressureheight adjustmentengine coolantfuel cap
Previous
Next
Load previous 8 pages

Page 625 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 4.(K975) RETURN CIRCUIT OPEN Measure the resistance of the (K975) return circuit between the ECM harness connector and the CKP sensor harness connector. Is the resistance less than 10 ohms? Ye s>> Go

Page 626 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 6.(K853) 5-VOLT SUPPLY CIRCUIT SHORTED TO (K975) RETURN CIRCUIT Measure the resistance between the (K853) 5-volt supply circuit and the (K975) return circuit in the sensor connector. Is the resistance

Page 627 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 9.(K24) SIGNAL CIRCUIT SHORTED TO (K853) 5-VOLT SUPPLY CIRCUIT Measure the resistance between the (K24) signal circuit and the (K853) 5-volt supply circuit in the sensor connector. Is the resistance g

Page 628 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual P0337-CRANKSHAFT POSITION (CKP) SENSOR VOLTAGE TOO LOW For a complete wiring diagramRefer to Section 8W.

Page 629 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual When Monitored: With the key on. Set Condition: Voltage detected at the CKP is below acalibrated value for a calibrated amountoftime. Possible Causes CKP SENSOR (K853) 5-VOLT SUPPLY CIRCUIT SHORTED TO

Page 630 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 3.(K853) 5-VOLT SUPPLY CIRCUIT SHORTED BATTERY NEGATIVE Measure the resistance between the (K853) 5-volt supply circuit and battery negative. Is the resistance greater than 100k Ohms? Ye s>> Go To 4 N

Page 631 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual P0338-CRANKSHAFT POSITION (CKP) SENSOR VOLTAGE TOO HIGH For a complete wiring diagramRefer to Section 8W.

Page 632 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual When Monitored: With the key on. Set Condition: Voltage detected at the CKP is above a calibrated value for a calibrated amount of time. Possible Causes (K853) 5-VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE
Load next 8 pages
Page:   < prev 1-10 ... 593-600 601-608 609-616 617-624 625-632 633-640 641-648 649-656 657-664 ... 5272 next >
technical datahomelinkoctanedifferentialwheeltowing
Popular search:
radiatoraudiowasher fluidremove seatswidthspare tire locationoil filter