2006 DODGE RAM SRT-10 Service Repair Manual

recommended oilservicefuel tank capacityclutchdashboardturn signal
Popular search:
coolant reservoirbattery replacementtire pressureclock settingengine oilwheel boltsradiator cap
Previous
Next
Load previous 8 pages

Page 2417 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 16. Remove the steering column assembly (6) from the vehicle. 17. Disassemble or transfer any components to be replaced. INSTALLATION WARNING: Before servicing the steering column the airbag system mu

Page 2418 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 7. Install the shifter cable (5). (Refer to 21 - TRANS- MISSION/TRANSAXLE/AUTOMATIC - 32RH/GEAR SHIFT CABLE - INSTALLATION) 8. Connect the wiring harness (8) to the column. 9. Install the clockspring

Page 2419 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 15. Install the steering column opening cover (1) and kneeblocker (2) (Refer to 23 - BODY/INSTRU- MENT PANEL/STEERING COLUMN OPENING COVER - INSTALLATION). 16. Install the negative battery terminal. 1

Page 2420 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual IGNITION SWITCH DESCRIPTION The ignition switch (1) is located on the steering col- umn. It is used as the main on/off switching device for most electrical components. The mechanical key cylin- der is

Page 2421 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual REMOVAL SERVICE PRECAUTIONS NOTE: The steering column on vehicles equipped with an automatic transmission is not equipped with an internal locking shaft with the ignition cylinder. Alternative methods

Page 2422 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 7. Disconnect the electrical connector at rear of igni- tion switch (4). 8. Remove ignition switch mounting screws (2). 9. Using a small screwdriver, push on locking tab (3) and remove switch (1) from

Page 2423 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 4. Install the tilt lever release bracket mounting screws. Tighten screws to 4.5 Nꞏm (40 in. lbs.). 5. Install the key cylinder. 6. Install steering column upper and lower shrouds. 7. Install the st

Page 2424 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual IGNITION SWITCH - SRT10 REMOVAL - SRT10 The ignition switch (1) attaches to the lock cylinder housing (2) on the end opposite the lock cylinder. For ignition switch terminal and circuit identification
Load next 8 pages
Page:   < prev 1-10 ... 2385-2392 2393-2400 2401-2408 2409-2416 2417-2424 2425-2432 2433-2440 2441-2448 2449-2456 ... 5272 next >
towlightsunroofnight visionclock settingsteering wheel
Popular search:
manual transmissionsport modeignitioncoolant levelseatsCompressionoil dipstick