2006 DODGE RAM SRT-10 Service Repair Manual

Page 9 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P0653-SENSOR REFERENCE VOLTAGE 2 CIRCUIT HIGH
For a complete wiring diagramRefer to Section 8W.

Page 10 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual When Monitored:
Ignition on.
Set Condition:
When the PCM recognizes the Auxiliary 5-volt Supply circuit voltage is toohigh. One Trip Fault. ETC light is
flashing.
Possible Causes
(F856) AUXILIARY 5-VO

Page 11 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 3.PCM
NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal
push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and

Page 12 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P0685-AUTO SHUTDOWN RELAY CONTROL CIRCUIT
For a complete wiring diagramRefer to Section 8W.

Page 13 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual When Monitored:
With ignition on. Battery voltage above 10 volts.
Set Condition:
The actual ASD state is not equal to the desired ASD state. One Trip Fault. Three good trips to turn off the
MIL.
Possi

Page 14 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 4.(K51) ASD RELAY CONTROL CIRCUIT OPEN
Disconnect the C3 PCM harness connector.
CAUTION: Do not probe the PCM harness connectors. Probing the
PCM harness connectors will damage the PCM terminals resul

Page 15 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 6.PCM
NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal
push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and

Page 16 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P0688-AUTO SHUTDOWN RELAY SENSE CIRCUIT LOW
For a complete wiring diagramRefer to Section 8W.
Page:   < prev 1-8 9-16 17-24 25-32 33-40 41-48 ... 5272 next >