2006 DODGE RAM SRT-10 Service Repair Manual

Page 945 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 3.(K1) MAP SIGNAL CIRCUIT SHORTED TO BATTERY VOLTAGE
Turn the ignition off.
Disconnect the C1 and C2 PCM harness connectors.
Ignition on, engine not running.
Measure the voltage on the (K1) MAP Signal

Page 946 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 5.(K1) MAP SIGNAL CIRCUIT SHORTED TO THE (F856) 5-VOLT SUPPLY CIRCUIT
Measure the resistance between the (K1) MAP Signal circuit and the
(F856) 5-volt Supply circuit in the MAP Sensor harness connecto

Page 947 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 7.PCM
NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal
push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and

Page 948 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P0111-INTAKE AIR TEMP PERFORMANCE
For a complete wiring diagramRefer to Section 8W.

Page 949 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual When Monitored:
With the ignition on and no Intake Air Temperature Sensor open/shorted faults present.
Set Condition:
After 5 warm cycles have occurred (coolant increases at least 22°C (40°F) to a m

Page 950 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 3.IAT SENSOR VOLTAGE BELOW 1.0 VOLT
Turn the ignition off.
Connect a jumper wire across the IAT Sensor harness connector.
Ignition on, engine not running.
With the scan tool, read the IAT voltage.
Is

Page 951 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 5.RESISTANCE IN THE (K900) SENSOR GROUND CIRCUIT
Turn the ignition off.
NOTE: Make sure the voltmeter leads meet the terminals in the
connector and that there is good terminal to wire connection.
NOTE

Page 952 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P0112-INTAKE AIR TEMP SENSOR VOLTAGE TOO LOW
For a complete wiring diagramRefer to Section 8W.