2006 DODGE RAM SRT-10 Service Repair Manual

compression ratiowiringbonnetsteeringweighttowing capacity
Popular search:
open gas tankwiringchild restraintwasher fluidalarmFuel injector removaltailgate
Previous
Next
Load previous 8 pages

Page 233 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 7.(K23) APP SENSOR NO.1 SIGNAL CIRCUIT SHORTED TO THE (K400) APP SENSOR NO.2 RETURN CIRCUIT Measure the resistance between the (K23) APP Sensor No.1 Signal cir- cuit and the (K400) Sensor No.2 Return

Page 234 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 9.(F855) 5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND Measure the resistance between ground and the (F855) 5-volt Supply circuit in the APP Sensor harness connector. Istheresistancebelow100ohms? Ye s>> Rep

Page 235 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual P2123-ACCELERATOR PEDAL POSITION SENSOR 1 CIRCUIT HIGH For a complete wiring diagramRefer to Section 8W.

Page 236 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual When Monitored: With the ignition on and no other APPS No.1 DTCs present. Set Condition: When APP Sensor No.1 voltage is too high. Engine will additionally idle if the brake pedal is pressed or has fa

Page 237 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 3.(K23) APP SENSOR NO.1 SIGNAL CIRCUIT SHORTED TO BATTERY VOLTAGE Turn the ignition off. Disconnect the C1, C2, and C3 PCM harness connectors. Ignition on, engine not running. Measure the voltage on t

Page 238 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 6.(K167) APP SENSOR NO.1 RETURN CIRCUIT OPEN CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal to pin connec

Page 239 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual P2127-ACCELERATOR PEDAL POSITION SENSOR 2 CIRCUIT LOW For a complete wiring diagramRefer to Section 8W.

Page 240 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual When Monitored: With the ignition on and no other APPS No.2 DTCs present. Set Condition: When the APP Sensor No.2 voltage is too low. Engine will only idle if the Brake pedal is Pressed or has failed.
Load next 8 pages
Page:   < prev 1-10 ... 201-208 209-216 217-224 225-232 233-240 241-248 249-256 257-264 265-272 ... 5272 next >
fuse chartlow oil pressurefuel cap releaselanguageengine oil capacityECO mode
Popular search:
spark plugsheight adjustmentfuel consumptiontireswasher fluidclockFuel pump relay