2006 DODGE RAM SRT-10 Service Repair Manual

bulbfuse box diagramcheck oilsteeringservice interval resetseats
Popular search:
transmission fluidCrank pulley boltsteering wheel adjustmentparking sensorswarningfuel pressurewheelbase
Previous
Next
Load previous 8 pages

Page 929 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual P0052-O2 SENSOR 2/1 HEATER CIRCUIT HIGH For a complete wiring diagramRefer to Section 8W.

Page 930 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual When Monitored: Battery voltage above 10.6 volts, ASD is powered up, and O2 heater is on. Set Condition: Desired state does not match Actual state. Possible Causes O2 HEATER TEST O2 SENSOR HEATER ELEM

Page 931 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 3.(K343) FUSED ASD RELAY OUTPUT CIRCUIT OPEN Ignition on, engine not running. With the scan tool, actuate the O2 Heater Test. Using a 12-volt test light connected to ground, probe the (K343) Fused ASD

Page 932 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 5.(K199) HEATER CONTROL CIRCUIT SHORTED TO GROUND Measure the resistance between ground and the (K199) O2 Heater Control (PWM) circuit. Istheresistancebelow100ohms? Ye s>> Repair the short to ground i

Page 933 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual P0071-AMBIENT/BATTERY TEMP SENSOR PERFORMANCE For a complete wiring diagramRefer to Section 8W.

Page 934 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual When Monitored: With the ignition on and no Battery Temperature Sensor Open or Short Faultspresent. Set Condition: After 5 warm cycles have occurred (coolant increases at least 22°C (40°F) to a mini

Page 935 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 3.(K25) BATTERY TEMP SENSOR SIGNAL With the scan tool, read the Battery Temp Sensor voltage with the Batt Temp Sensor still disconnected. Is the voltage above 4.6 volts? Ye s>> Go To 4 No>> Go To 7 4.

Page 936 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 6.RESISTANCE IN THE (K900) SENSOR GROUND CIRCUIT Turn the ignition off. NOTE: Make sure the voltmeter leads meet the terminals in the connector and that there is good terminal to wire connection. NOTE
Load next 8 pages
Page:   < prev 1-10 ... 897-904 905-912 913-920 921-928 929-936 937-944 945-952 953-960 961-968 ... 5272 next >
lockoverheatingmaintenanceoil temperaturechild locktow
Popular search:
windowwheel boltsheight adjustmentengine oil capacityoil changejump cableWater pump