2006 DODGE RAM SRT-10 Service Repair Manual

Page 497 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P0111-INTAKE AIR TEMPERATURE (IAT) SENSOR RATIONALITY
For a complete wiring diagramRefer to Section 8W.

Page 498 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual When Monitored:
While the engine is running.
Set Condition:
The ECM does not read a change in value from the sensor over time.
Possible Causes
FAILED IAT SENSOR
INTERMITTENT CONDITION
Always perform t

Page 499 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P0112-INTAKE AIR TEMPERATURE (IAT) SENSOR VOLTAGE TOO LOW
For a complete wiring diagramRefer to Section 8W.

Page 500 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual When Monitored:
With the ignition on and battery voltage greater than 10.4 volts.
Set Condition:
The circuit voltage to the ECM falls below a calibrated threshold for a certain period of time.
Possibl

Page 501 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 3.(K21) SIGNAL CIRCUIT SHORTED TO GROUND CIRCUIT
Turn the ignition off.
Disconnect the ECM harness connector.
Check connectors - Clean/repair as necessary.
Measure the resistance between the engine gr

Page 502 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 5.(F855) 5-VOLT SUPPLY CIRCUIT SHORTED TO (K916) RETURN CIRCUIT
Reconnect the ECM harness connector connected.
Turn the ignition on.
Measure the voltage between the (F855) 5-volt supply circuit and th

Page 503 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 7.ECM
Reconnect the ECM harness connector.
Reconnect the intake air temp sensor harness connector.
Turn the ignition on.
While monitoring with scan tool, disconnect the temperature sensor
Did the DTC

Page 504 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P0113-INTAKE AIR TEMPERATURE (IAT) SENSOR VOLTAGE TOO HIGH
For a complete wiring diagramRefer to Section 8W.