2006 DODGE RAM SRT-10 Service Repair Manual

Page 121 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual When Monitored:
Ignition on and vehicle moving. Brake pedal must not be applied.
Set Condition:
The PCM recognizes front axle speed is greater than rear axle speed. One tripfault.
Possible Causes
ACTI

Page 122 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 3.PCM
NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal
push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and

Page 123 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P1521–INCORRECT ENGINE OIL TYPE
When Monitored:
Engine Running.
Set Condition:
Using the oil pressure, oil temperature and other vital engine inputs the PCM can determine the engine oil
viscosity. I

Page 124 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P1572-BRAKE PEDAL STUCK ON
For a complete wiring diagramRefer to Section 8W.

Page 125 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual When Monitored:
Ignition on. In plant mode only.
Set Condition:
PCM recognizes the Brake Pedal couldnot electrically indicate the applied (On) position with both switch
inputs. One trip fault.
Possibl

Page 126 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 4.(B29) BRAKE SWITCH NO.1 SIGNAL CIRCUIT OPEN
Disconnect the C3 PCM harness connector.
CAUTION: Do not probe the PCM harness connectors. Probing the
PCM harness connectors will damage the PCM terminal

Page 127 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 6.PCM
NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal
push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and

Page 128 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P1573-BRAKE PEDAL STUCK OFF
For a complete wiring diagramRefer to Section 8W.