2006 DODGE RAM SRT-10 Service Repair Manual

radio antennalockairbagheaterseat memory lane assist
Popular search:
tire pressureair conditionbrakegas typeairbag offlightsairbag disable
Previous
Next
Load previous 8 pages

Page 617 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual When Monitored: While the engine is running. Set Condition: The ECM no longer detects a signal from the Crankshaft Position Sensor. Possible Causes OTHER DTC’S P0337 PRESENT CKP SENSOR VISUAL DAMAGE

Page 618 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 3.VISUAL DAMAGE Visually inspect the sensor, engine belt, sensor connector, and the ECM connector. Is there any damage? Ye s>> Repair or replace the sensor, engine belt, harness, or the ECM. Perform P

Page 619 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 6.(K853) 5-VOLT SUPPLY CIRCUIT OPEN Measure the resistance of the (K853) 5-volt supply circuit between the ECM harness connector and the CKP sensor harness connector. Is the resistance less than 10 oh

Page 620 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 8.(K24) SIGNAL CIRCUIT SHORTED TO (K975) RETURN CIRCUIT Measure the resistance between the (K24) signal circuit and the (K975) return circuit in the sensor connector. Is the resistance greater than 10

Page 621 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 11 .(K853) 5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND Measure the resistance between the (K853) 5-volt supply circuit and ground. Is the resistance greater than 100k Ohms? Ye s>> Go To 12 No>> Repair the

Page 622 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual P0336-CRANKSHAFT POSITION (CKP) SENSOR SIGNAL For a complete wiring diagramRefer to Section 8W.

Page 623 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual When Monitored: With the key on. Set Condition: The voltage detected at the Crankshaft position sensor is below a calibrated value. Possible Causes CKP SENSOR (K24) SIGNAL CIRCUIT OPEN (K853) 5-VOLT S

Page 624 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 2.(K24) SIGNAL CIRCUIT OPEN Disconnect the ECM harness connectors. Disconnect the CKP sensor harness connector. Check connectors - Clean/repair as necessary. Measure the resistance of the (K24) signal
Load next 8 pages
Page:   < prev 1-10 ... 585-592 593-600 601-608 609-616 617-624 625-632 633-640 641-648 649-656 ... 5272 next >
navigation systemnight visioncatalytic converterrear entertainmentoil pressureweight
Popular search:
Crankshaftwidthhood releaserun flatwarning lightsfuel consumptionjump cable