2006 DODGE RAM SRT-10 Service Repair Manual

fuel fill door releasephonerimsload capacitycoolingnavigation system
Popular search:
load capacityfuel pumpcoolant capacitywarning lightbolt patternbuttonsfuel filter
Previous
Next
Load previous 8 pages

Page 3665 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual Theory of Operation The Governor Pressure Sensor is used by the ECM to adjust the Governor Pressure to a desired level for shifts in first, second, and third gear. If the ECM detects the monitored sen

Page 3666 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 2.CHECK FOR OTHER TRANSMISSION DTC’S PRESENT Are there any Park/Neutral or other Transmission DTCs present? Ye s>> Refer to the Transmission category and perform the appropriate symptom(s). If a Par

Page 3667 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 5.CHECK THE (T38) GOVERNOR PRESSURE SENSOR SIGNAL CIRCUIT FOR A SHORT TO VOLTAGE Ignition on, engine not running. Measure the voltage of the (T38) Governor Pressure Sensor Signal cir- cuit in the Tran

Page 3668 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 7.CHECK THE (T38) GOVERNOR PRESSURE SENSOR SIGNAL CIRCUIT OR AN OPEN INTERNAL Remove the Transmission Oil Pan. (Refer to 21 - TRANSMISSION/ TRANSAXLE/AUTOMATIC - 48RE/FLUID - STANDARD PROCEDURE) Recon

Page 3669 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 9.CHECK THE (T38) GOVERNOR PRESSURE SENSOR SIGNAL CIRCUIT FOR A SHORT TO VOLTAGE INTERAL NOTE: The Transmission Solenoid Assembly harness connector must be connected before proceeding. Ignition on, en

Page 3670 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual 11 .INTERMITTENT WIRING AND CONNECTORS The conditions necessary to set this DTC are not present at this time. Use the Freeze Frame Data to help duplicate the conditions in which the DTC originally set

Page 3671 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual P0869-GOVERNOR PRESSURE SENSOR VOLTS TOO LOW (DIESEL) For a complete wiring diagramRefer to Section 8W

Page 3672 of 5267

DODGE RAM SRT-10 2006 Service Repair Manual Theory of Operation The Governor Pressure Sensor is used by the ECM to adjust the Governor Pressure to a desired level for shifts in first, second, and third gear. If the ECM detects the monitored sen
Load next 8 pages
Page:   < prev 1-10 ... 3633-3640 3641-3648 3649-3656 3657-3664 3665-3672 3673-3680 3681-3688 3689-3696 3697-3704 ... 5272 next >
manual transmissionmaintenancepairing phoneservice interval resetbrake rotoropen hood
Popular search:
oil dipstickfold seatsclockchild seatheaterfuel filter locationfuel filter