2006 DODGE RAM SRT-10 Service Repair Manual

Page 1001 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual When Monitored:
With battery voltage greater than 9 volts, at a cold start, ECT less than 147°F, battery temperature sensor
equal to or less than 27°F, and engine at idle for at least 12 seconds.
Se

Page 1002 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 3.(K99) O2 1/1 HEATER CONTROL CIRCUIT OPEN
Disconnect the C3 PCM harness connector.
Measure the resistance of the (K99) O2 1/1 Heater Control circuit from
the O2 harness connector to the PCM harness c

Page 1003 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P0136-O2 SENSOR 1/2 HEATER CIRCUIT MALFUNCTION
For a complete wiring diagramRefer to Section 8W.

Page 1004 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual When Monitored:
Ignition ON, with battery voltage greater than 10.4 volts.
Set Condition:
The state of the PCM relay control circuit, between the PCM and relay coil, does not match the desired state.

Page 1005 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 4.(K127) O2 HEATER RELAY CONTROL CIRCUIT OPEN
Turn the ignition off.
Disconnect the PCM harness connectors.
Measure the resistance of the (K127) O2 Heater Relay Control circuit from the PDC (Heater Re

Page 1006 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual P0137-O2 SENSOR 1/2 CIRCUIT LOW
For a complete wiring diagramRefer to Section 8W.

Page 1007 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual When Monitored:
At a cold start, engine coolant below 98°F, Ambient/Battery Sensor readingwithin27°F,andEngineCoolant
Temperature above 170°F on the previous key off.
Set Condition:
The Oxygen Sens

Page 1008 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 3.(K141) O2 SENSOR 1/2 SIGNAL CIRCUIT SHORTED TO GROUND
Turn the ignition off.
Disconnect the PCM harness connectors.
Measure the resistance between ground and the (K141) O2 Sensor 1/2
Signal circuit