2006 DODGE RAM SRT-10 compression ratio

[x] Cancel search: compression ratio

Page 449 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 4.TP SENSOR NO.1 VOLTAGE GREATER THAN0.92 VOLTS WITH THROTTLE CLOSED
With the scan tool, read Throttle Position Sensor No.1 voltage.
Throttle must be against its stop.
Is the voltage 0.92 or less with

Page 1064 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 9.ECT SENSOR OPERATION
NOTE: For this test to be valid, the thermostat must be operating correctly.
NOTE: This test works best if performed on a cold engine (cold soak)
Ignition on, engine not running

Page 1077 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 9.ECT SENSOR OPERATION
NOTE: For this test to be valid, the thermostat must be operating correctly.
NOTE: This test works best if performed on a cold engine (cold soak)
Ignition on, engine not running

Page 1129 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 8.FUEL INJECTOR OPERATION
WARNING: The fuel system is under a constant pressure (even with the engineoff). Before testing or ser-
vicing any fuel system hose, fitting or line, the fuel system pressure

Page 1136 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual NOTE: The pressure should not fall below 241 KPa (35 psi).
Does the pressure fall below the listed specification?
Ye s>>
Replace the leaking Fuel Injector(s).
Perform the POWERTRAIN VERIFICATION TEST.

Page 1145 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual 8.FUEL INJECTOR OPERATION
WARNING: The fuel system is under a constant pressure (even with the engineoff). Before testing or ser-
vicing any fuel system hose, fitting or line, the fuel system pressure

Page 1154 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual NOTE: The pressure should not fall below 241 KPa (35 psi).
Does the pressure fall below the listed specification?
Ye s>>
Replace the leaking Fuel Injector(s).
Perform the POWERTRAIN VERIFICATION TEST.

Page 1163 of 5267

DODGE RAM SRT-10 2006  Service Repair Manual NOTE: The pressure should not fall below 241 KPa (35 psi).
Does the pressure fall below the listed specification?
Ye s>>
Replace the leaking Fuel Injector(s).
Perform the POWERTRAIN VERIFICATION TEST.
Page:   1-8 9-16 17-24 25-32 33-40 ... 40 next >