2003 LEXUS LS430 Factory Repair Manual

remove seats4WDtransmission oiloil capacitybulbclock reset
Popular search:
remote controlradiocheck transmission fluidbrake padscruise controlradiatorengine oil
Previous
Next
Load previous 8 pages

Page 73 of 4500

LEXUS LS430 2003 Factory Repair Manual There is no clearance between the sensor and the front steering knuckle. NG: REPLACE FRONT SPEED SENSOR Fig. 52: Inspecting Front Speed Sensor Gap Courtesy of TOYOTA MOTOR SALES, U.S.A., INC. O

Page 74 of 4500

LEXUS LS430 2003 Factory Repair Manual Refer to DTC C0200/31 RIGHT FRONT SPEED SENSORor DTC C0205/32 LEFT FRONT SPEED SENSOR . Fig. 53: DTC C0210/33 And DTC C0215/34 Detecting Condition And Trouble Area Courtesy of TOYOTA MOTOR SALES,

Page 75 of 4500

LEXUS LS430 2003 Factory Repair Manual corresponding to a DTC (see CHECK FOR INTERMITTENT PROBLEMS ). MEASUREMENT ITEM / RANGE (DISPLAY) DESCRIPTION OK: Go to next step There are no momentary interruption. HINT: Perform the above in

Page 76 of 4500

LEXUS LS430 2003 Factory Repair Manual NG: Go to step 4 OK: Go to next step 3.INSPECT SPEED SENSOR AND SENSOR ROTOR SERRATIONS Fig. 55: Normal Signal Waveform Courtesy of TOYOTA MOTOR SALES, U.S.A., INC. INSPECTION USING OSCILLOSCO

Page 77 of 4500

LEXUS LS430 2003 Factory Repair Manual fluctuation in the output voltage becomes greater. When noise is identified in the waveform on the oscilloscope, error signals are generated due to the speed sensor rotor's scratches, looseness

Page 78 of 4500

LEXUS LS430 2003 Factory Repair Manual Standard: TESTER CONNECTION SPECIFIED CONDITION LH: TESTER CONNECTION SPECIFIED CONDITION RH: e. Measure the resistance according to the value (s) in the table below. Standard: TESTER CONNECTI

Page 79 of 4500

LEXUS LS430 2003 Factory Repair Manual Fig. 57: Identifying Skid Control ECU Connector And Rear Speed Sensor Connector Terminals Courtesy of TOYOTA MOTOR SALES, U.S.A., INC. a. Disconnect the skid control ECU connector and the rear speed

Page 80 of 4500

LEXUS LS430 2003 Factory Repair Manual TESTER CONNECTION SPECIFIED CONDITION RH: c. Measure the resistance according to the value (s) in the table below. Standard: TESTER CONNECTION SPECIFIED CONDITION LH: TESTER CONNECTION SPECIFIED
Load next 8 pages
Page:   < prev 1-10 ... 41-48 49-56 57-64 65-72 73-80 81-88 89-96 97-104 105-112 ... 4504 next >
CD playercabin filteropen bonnetinstrument panelspare wheeltransmission fluid
Popular search:
mirrorModulatedspare tireaudioground clearancepark assistStarter