Page 2153 of 4500
Fig. 113: Checking Rear Drive Pinion Companion Flange Sub-Assy Rear Preload
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
s.INSTALL REAR DIFFERENTIAL CASE SUB-ASSY
a. Insert the differential case from the ring gear tooth side to install.
Page 2154 of 4500
Fig. 114: Installing Rear Differential Case Sub-Assy
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
t.INSTALL REAR DIFFERENTIAL CASE BEARING
a. Using SST and a hammer, install the drive pinion side outer race.
SST 09608-32010, 09950-70010 (09951-07200)
HINT:
Tap in the outer race until half of the side gear shaft snap ring groove of the differential
carrier can be seen.
Page 2155 of 4500
Fig. 115: Installing Drive Pinion Side Outer Race
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Place the SST to the differential carrier.
SST 09571-50010
c. Ti
ghten the SST bolt until the SST disc lightly touches to the case bearing (outer race).
Page 2156 of 4500
Fig. 116: Placing SST To Differential Carrier
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
d. Using SST and a hammer, install the ring gear side outer race.
SST 09950-70010 (09951-07200), 09608-32010
HINT:
Tap in the outer race until it touches the case bearin
g roller.
Page 2157 of 4500
Fig. 117: Installing Ring Gear Side Outer Race
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
52.INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT SNAP RING
a. Using snap ring pliers, install the side gear shaft snap ring in the differential carrier on the ring gear
side.
HINT:
Use the side
gear shaft snap ring installed when performing tooth contact adjustment.
Page 2158 of 4500
Fig. 118: Installing Side Gear Shaft Snap Ring In Differential Carrier On Ring Gear Side
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Set a dial indicator on the differential carrier.
c. Tighten the SST bolt to alter the differential carrier's shape.
Shaped limit: 0.20 mm (0.0079 in.)
Page 2159 of 4500
Fig. 119: Setting Dial Indicator On Differential Carrier
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
d. Using snap ring pliers, install the side gear shaft snap ring on the drive pinion side.
HINT:
Use the side gear shaft snap ring installed at tooth contact adjustment.
Page 2160 of 4500
Fig. 120: Installing Side Gear Shaft Snap Ring On Drive Pinion Side
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
e. Remove the dial indicator, tap the differential carrier on the drive pinion side using a plastic
hammer to stabilize the case bearin
g.