2007 ISUZU KB P190 Workshop Repair Manual

rimssat navclutchgas typefuel pumpstop start
Popular search:
coolant reservoiroil additivespower steering fluidlow oil pressureautomatic transmissionchange timecoolant level
Previous
Next
Load previous 8 pages

Page 3177 of 6020

ISUZU KB P190 2007 Workshop Repair Manual Engine Cooling – V6 Engine Page 6B1–42 5 Drain the coolant from the system. Refer to 3.3 Draining and Filling Cooling System in this Section. 6 Remove the four coolant pump pulley at

Page 3178 of 6020

ISUZU KB P190 2007 Workshop Repair Manual Engine Cooling – V6 Engine Page 6B1–43 Inspect 1 Rotate the coolant pump hub (1). The hub and impeller (2) should turn straight and smoothly. If the hub wobbles, is noisy or feels rough w

Page 3179 of 6020

ISUZU KB P190 2007 Workshop Repair Manual Engine Cooling – V6 Engine Page 6B1–44 5 Install coolant pump pulley and attaching bolts (1). 6 Install drive belt (reverse to removal procedures) and ensure that the drive belt is aligne

Page 3180 of 6020

ISUZU KB P190 2007 Workshop Repair Manual Engine Cooling – V6 Engine Page 6B1–45 3.11 Coolant Outlet Housing Remove Refer to 3.1 Service Notes in this Section, for important safety items. 1 Allow engine to cool to ambient te

Page 3181 of 6020

ISUZU KB P190 2007 Workshop Repair Manual Engine Cooling – V6 Engine Page 6B1–46 6 Remove the two coolant outlet housing attaching bolts (1), and remove coolant outlet housing (2). 7 Remove and discard coolant outlet housing O-ri

Page 3182 of 6020

ISUZU KB P190 2007 Workshop Repair Manual Engine Cooling – V6 Engine Page 6B1–47 Disconnection of the battery affects certain vehicle electronic systems. Refer to 1.1 WARNING, CAUTION and NOTES, before removing the ground lead

Page 3183 of 6020

ISUZU KB P190 2007 Workshop Repair Manual Engine Cooling – V6 Engine Page 6B1–48 Install 1 Ensure that the coolant inlet pipe and thermostat housing mating surfaces are clean and dry. 2 Install new O-ring to the coolant inlet pip

Page 3184 of 6020

ISUZU KB P190 2007 Workshop Repair Manual Engine Cooling – V6 Engine Page 6B1–49 4 Depress tang on main wiring harness to cooling fan motor wiring harness connector and separate connector (1). Figure 6B1 – –– – 54 7
Load next 8 pages
Page:   < prev 1-10 ... 3145-3152 3153-3160 3161-3168 3169-3176 3177-3184 3185-3192 3193-3200 3201-3208 3209-3216 ... 6024 next >
recommended oilheight adjustmentrefrigerant typeair conditionsensormanual radio set
Popular search:
length4wd switchwheel sizefuel consumptionSECURITYsteering rackservice indicator