2007 ISUZU KB P190 Workshop Repair Manual

fuel tank removalfuel capnavigation systemchild lockrun flatheating
Popular search:
remote controlrun flatadding oilsensordiagnostic menucoolant levelopen bonnet
Previous
Next
Load previous 8 pages

Page 361 of 6020

ISUZU KB P190 2007 Workshop Repair Manual 3C-40 FRONT SUSPENSION Upper Control Arm Upper Control Arm and Associated Parts RTW 440LF001301 Legend (1) Bolt and Plate (2) Camber Shims (3) Caster Shims (4) Nut Assembly

Page 362 of 6020

ISUZU KB P190 2007 Workshop Repair Manual FRONT SUSPENSION 3C-41 4. Support lower control arm with a harness. 5. Remove speed sensor harness. 6. Remove nut and cotter pin then remove knuckle using remover 5-8840-2121-0. CAUTION: Be

Page 363 of 6020

ISUZU KB P190 2007 Workshop Repair Manual 3C-42 FRONT SUSPENSION Installation 1. Install fulcrum pin. 2. Install bushing by using installer 5-8840-0256-0 and 5-8840-2307-0. RTW 340SH000701 RTW 340SH000801 3. Install

Page 364 of 6020

ISUZU KB P190 2007 Workshop Repair Manual FRONT SUSPENSION 3C-43 9. Install the camber shims (a) between the chassis frame and fulcrum pin. RTW 53CSH000201 10. Install nut assembly. 11. Install bolt and plate (a), and then tighte

Page 365 of 6020

ISUZU KB P190 2007 Workshop Repair Manual 3C-44 FRONT SUSPENSION Lower Control Arm Lower Control Arm and Associated Parts RTW 33CLF000201 Legend (1) Cam Bolt (2) Bush, Front (3) Cam Plate and Nut (4) Nut, Rear (5) Bush

Page 366 of 6020

ISUZU KB P190 2007 Workshop Repair Manual FRONT SUSPENSION 3C-45 Removal 1. Raise the vehicle and support the frame with suitable safety stands. 2. Remove wheel and tire assembly. Refer to W heel in this section. 3. Remove the tie-rod

Page 367 of 6020

ISUZU KB P190 2007 Workshop Repair Manual 3C-46 FRONT SUSPENSION Inspection and Repair Make necessary correction or replace parts if wear, damage, corrosion or any other abnormal condition is found through inspection. Check the followin

Page 368 of 6020

ISUZU KB P190 2007 Workshop Repair Manual FRONT SUSPENSION 3C-47 14. Install cam plate and nut then tighten lower link nut finger-tight. NOTE: Apply oil to the thread. NOTE: Tighten the nut or bolt with the parts in the position shown
Load next 8 pages
Page:   < prev 1-10 ... 329-336 337-344 345-352 353-360 361-368 369-376 377-384 385-392 393-400 ... 6024 next >
instrument clusterflat tirebuttonsheadlampdashboardparking brake
Popular search:
Diagramtransmission fluidcoolantengine mountwheel bolt torquecheck engineair filter