Page 1521 of 6020
ENGINE MECHANICAL (4JK1/4JJ1) 6A-161
Oil Pressure SW
Components
RTW 76AMF000401
Legend 1. Cylinder Block
2. Gasket
3. Nipple; Oil Pressure W arning SW 4. Oil Pressure SW
5. Nipple; Oil Gallery
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 1522 of 6020

6A-162 ENGINE MECHANICAL (4JK1/4JJ1)
Removal
1. Remove the oil pressure SW .
2. Remove the nipple; oil gallery.
3. Remove the nipple; oil pressure warning SW and gasket.
Inspection
Check the continuity between the switch terminal and
the body grounding in a no-load condition.
If there is no connectivity, replace with normal parts.
LNW 21HSH003301
Circuit check
1. Turn the starter switch to ON.
2. Disconnect the oil pressure switch connector, and confirm that the oil pressure-warning lamp lights
when the connector on the harness side is
grounded.
If the warning lamp does not light up, check the circuit between the meter and the oil pressure
switch, and repair the disconnected locations.
LNW 21HSH003401
Installation
1. Install the nipple; oil gallery, oil pressure warning
SW and gasket.
Tightening torque: 25 N ⋅
⋅⋅
⋅
m (2.5 kg ⋅
⋅⋅
⋅
m/18 lb ft)
2. Install the Nipple. Tightening torque: 15 N ⋅
⋅⋅
⋅
m (1.5 kg ⋅
⋅⋅
⋅
m/11 lb ft)
3. Install the oil pressure SW . Tightening torque: 15 N ⋅
⋅⋅
⋅
m (1.5 kg ⋅
⋅⋅
⋅
m/11 lb ft)
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 1523 of 6020
ENGINE MECHANICAL (4JK1/4JJ1) 6A-163
Air Cleaner Element
Removal
1. Remove the air cleaner cover fixing clip.
2. Remove the air cleaner element assembly.
Cleaning
Dry type element
• Rotate the element with your hand while applying
compressed air to the inside of the element. This
will blow the dust free.
Compressed air pressure kPa (kg/cm2 /psi)
392 − 490 (4 − 5/57 − 71)
Standard Output
LNW 46ASH003201
High Output
LNW 71BSH000201
Installation
1. Install the air cleaner element assembly.
2. Install the air cleaner cover.
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 1524 of 6020

ENGINE COOLING (4JK1/4JJ1) 6B-1
SECTION 6B
ENGINE COOLING
TABLE OF CONTENTS
Main Data and Specifications ............................. 6B-2
General Description............................................ 6B-3 Coolant Flow ................................................... 6B-3
W ater Pump .................................................... 6B-4
Thermostat ...................................................... 6B-4
Radiator ........................................................... 6B-5
Antifreeze Solution .......................................... 6B-5
Diagnosis............................................................ 6B-6
Draining and Refilling Cooling System ............... 6B-7
W ater Pump ....................................................... 6B-8 Removal .......................................................... 6B-8
Inspection and Repair ..................................... 6B-9
Installation ....................................................... 6B-9
Thermostat ......................................................... 6B-11 Removal .......................................................... 6B-11
Inspection and Repair ..................................... 6B-11
Operating Test of Thermostat ......................... 6B-11
Installation ....................................................... 6B-12
Radiator .............................................................. 6B-13 Radiator and Associated Parts........................ 6B-13
Removal .......................................................... 6B-14
Inspection and Repair ..................................... 6B-15
Radiator Cap ................................................... 6B-15
Radiator Core .................................................. 6B-15
Flushing the Radiator ...................................... 6B-15
Cooling System Leakage Check ..................... 6B-15
Installation ....................................................... 6B-16
Engine Coolant Change .................................. 6B-16
Fan Clutch with Cooling Fan .............................. 6B-17 Inspection and Repair ..................................... 6B-17
Special Tools................................................... 6B-18
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 1525 of 6020

6B-2 ENGINE COOLING (4JK1/4JJ1)
Main Data and Specifications
Description Item
M/T A/T
Cooling system
W ater pump type
Pump to crankshaft speed ratio (To 1)
Delivery volume lit (US/UK gal)/min
Pump speed at 5600 rpm
W ater temperature at 30 °C (86 °F)
Pump bearing type
Thermostat type
Valve initial opening temperature °C ( °F)
Valve full opening temperature °C ( °F)
Valve lift at fully open position mm (in) Engine coolant forced circulation
Centrifugal impeller type 1.25
240 (63.1/53.3)
Double row shaft
W ax pellet with jiggle valve 85 (185)
100 (212) 10 (0.39)
Radiator Tube type corrugated
Heat radiation capacity kW (kcal/h) 93 (80.2)
Heat radiation area m2 (ft2) 11.63 (125.2)
Radiator front area m2 (ft2) 0.28 (3)
Radiator dry weight N (kg/lb) 52 53
Radiator cap valve opening pressure kPa (kg/cm2/psi) 93.3 - 122.7 (0.95 - 1.25/13.5 - 17.8)
Engine coolant capacity lit (U.S pint) 4.0 (8.5) 4.0 (8.5)
Engine coolant total capacity lit (U.S pint) 8.7 (18.4) 8.6 (18.2)
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 1526 of 6020
ENGINE COOLING (4JK1/4JJ1) 6B-3
General Description
Coolant Flow
RTW 76BLF000301
The engine cooling system consists of the radiator, the
water pump, the cooling fan, and the thermostat.
To quickly increase cold engine coolant temperature fo
r
smooth engine operation, the coolant is circulated by
the water pump and thermostat through the bypass pipe
and back to the cylinder body.
The coolant does not circulate through the radiator.
W hen the coolant temperature reaches the specified
value, the thermostat will begin to open and a graduall
y
increasing amount of coolant will circulate through the
radiator.
The thermostat will be fully open when the coolant
temperature reaches the specified value. All of the
coolant is now circulating through the radiator fo
r
effective engine cooling.
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 1527 of 6020
6B-4 ENGINE COOLING (4JK1/4JJ1)
Water Pump
RTW 56BSF000101
A centrifugal type water pump forcefully circulates the
coolant through the cooling system.
The water pump is not a disassembled type.
Thermostat
RTW 56BSF000201
A wax pellet type thermostat is used.
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 1528 of 6020
ENGINE COOLING (4JK1/4JJ1) 6B-5
Radiator
The radiator is a tube type with corrugated fins. In order
to raise the boiling point of the coolant, the radiator is
fitted with a cap in which the valve is operated at 93.3 -
122.7 kPa (0.95 - 1.25 kg / cm
2 / 13.5 - 17.8 psi)
pressure. (No oil cooler provided for M/T)
RTW 56BSH000301
Antifreeze Solution
NOTE:
Antifreeze solution + W ater = Total cooling system
capacity.
Total Cooling System Capacity Lit
(US / UK gal) (US pint)
M/T 8.7 (2.3/1.9) (18.4)
A/T 8.6 (2.3/1.9) (18.2)
See section 0B MAINTENANCE AND LUBRICATION .
F06RW 005
NOTE:
To maintain the corrosion resistance of the aluminum
radiator, water and antifreeze must be combined in a
1:1 solution (50% antifreeze and 50% water).
RTW 76BSH000201
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007