Page 3249 of 4801
INSIDE MIRRORMIR-19
< REMOVAL AND INSTALLATION >
C
D E
F
G H
I
J
K
M A
B
MIR
N
O P
REMOVAL AND INSTALLATION
INSIDE MIRROR
Exploded ViewINFOID:0000000009463529
Removal and InstallationINFOID:0000000009463530
REMOVAL
1. Remove the inside mirror base screw.
2. Disconnect the harness connector from the inside mirror.
3. Slide the inside mirror upward and remove.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Apply Genuine Mirror Adhesive or equivalent to bonding surface of mirror base. Refer to GI-21, "Rec-
ommended Chemical Products and Sealants".
1. Inside mirror harness 2. I nside mirror 3. Mirror base
A. Screw
ALLIA1157ZZ
ALKIA0069GB
Revision: November 20132014 Altima NAMRevision: November 20132014 Altima NAM
Page 3250 of 4801
MIR-20
< REMOVAL AND INSTALLATION >
DOOR MIRROR
DOOR MIRROR
Exploded ViewINFOID:0000000009463531
Removal and InstallationINFOID:0000000009463532
REMOVAL
1. Remove the front door finisher. Refer to INT-15, "Removal and Installation".
2. Disconnect the harness connectors (A) from the door mirror cor- ner finisher.
3. Release the clips and pawls using a suitable tool and remove the door mirror corner finisher (1).
• Push suitable trim tool underneath finisher, and then pry out- ward as shown. Move tool further up near upper fastened
area, and then pry outward again.
: Clip
: Pawl
1. Door mirror cover 2. Side turn signal lamp (if equipped) 3. Door mirror housing assembly
4. Door mirror actuator 5. Door mirror glass and holder
ALLIA1166ZZ
AWLIA2218ZZ
Revision: November 20132014 Altima NAMRevision: November 20132014 Altima NAM
Page 3251 of 4801
DOOR MIRRORMIR-21
< REMOVAL AND INSTALLATION >
C
D E
F
G H
I
J
K
M A
B
MIR
N
O P
4. Remove the door mirror nuts (A) and the door mirror assembly (1).
INSTALLATION
Installation is in the reverse order of removal. Door mirror nut: : 5.1 N·m (0.5 kg-m, 4 ft-lb)
ALLIA1161ZZ
Revision: November 20132014 Altima NAMRevision: November 20132014 Altima NAM
Page 3252 of 4801
MIR-22
< REMOVAL AND INSTALLATION >
DOOR MIRROR GLASS
DOOR MIRROR GLASS
Removal and InstallationINFOID:0000000009463533
REMOVAL
1. Position the door mirror glass surface upward.
2. Apply protective tape (A) to mirror housing.
3. Insert a suitable tool (B) as shown and gently release the door mirror glass (1) from the door mirror actuator.
CAUTION:
Do not use excessive force or damage or breakage of the
door mirror glass could occur.
INSTALLATION
Installation is in the reverse order of removal.
AWLIA1999ZZ
Revision: November 20132014 Altima NAMRevision: November 20132014 Altima NAM
Page 3253 of 4801
DOOR MIRROR REAR FINISHERMIR-23
< REMOVAL AND INSTALLATION >
C
D E
F
G H
I
J
K
M A
B
MIR
N
O P
DOOR MIRROR REAR FINISHER
Removal and InstallationINFOID:0000000009463534
REMOVAL
1. Remove the door mirror glass. Refer to MIR-22, "Removal and Installation".
2. Release the door mirror rear finisher pawls (A) using a suitable tool.
3. Remove the door mirror rear finisher.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check that pawls are securely engaged.
ALLIA1175ZZ
Revision: November 20132014 Altima NAMRevision: November 20132014 Altima NAM
Page 3254 of 4801
MIR-24
< REMOVAL AND INSTALLATION >
DOOR MIRROR ACTUATOR
DOOR MIRROR ACTUATOR
Removal and InstallationINFOID:0000000009463535
REMOVAL
1. Remove the door mirror glass. Refer to MIR-22, "Removal and Installation".
2. Remove the mirror actuator screw (A).
3. Release the door mirror actuator pawls (A) using a suitable tool. : Pawl
4. Disconnect the harness connector fr om the door mirror actuator
(1) and remove.
INSTALLATION
Installation is in the reverse order of removal.
ALLIA1169ZZ
Revision: November 20132014 Altima NAMRevision: November 20132014 Altima NAM
Page 3255 of 4801
DOOR MIRROR REMOTE CONTROL SWITCHMIR-25
< REMOVAL AND INSTALLATION >
C
D E
F
G H
I
J
K
M A
B
MIR
N
O P
DOOR MIRROR REMOTE CONTROL SWITCH
Removal and InstallationINFOID:0000000009463536
REMOVAL
1. Release the pawls and remove the front door pull handle outer finisher. Refer to INT-15, "Exploded View".
2. Disconnect the harness connector from the door mirror remote control switch.
3. Release the pawls and remove the door mirror remote control switch from the front door finisher.
INSTALLATION
Installation is in the reverse order of removal.
Revision: November 20132014 Altima NAMRevision: November 20132014 Altima NAM
Page 3256 of 4801

MWI
MWI-1
DRIVER INFORMATION & MULTIMEDIA
C
D E
F
G H
I
J
K L
M B
SECTION MWI
A
O P
CONTENTS
METER, WARNING LAMP & INDICATOR
PRECAUTION ................ ...............................4
PRECAUTIONS .............................................. .....4
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TEN-
SIONER" ............................................................. ......
4
PREPARATION ............................................5
PREPARATION .............................................. .....5
Special Service Tools .......................................... ......5
Commercial Service Tools ........................................5
SYSTEM DESCRIPTION ..............................6
COMPONENT PARTS ................................... .....6
METER SYSTEM .........................................................6
METER SYSTEM : Compo nent Parts Location ........6
METER SYSTEM : Component Description ....... ......7
SYSTEM ..............................................................9
METER SYSTEM .........................................................9
METER SYSTEM : System Diagram ........................9
METER SYSTEM : System Description ....................9
METER SYSTEM : Arrangem ent of Combination
Meter ................................................................... ....
10
METER SYSTEM : Fail-Safe ..................................10
SPEEDOMETER ................ ........................................11
SPEEDOMETER : System Diagram ................... ....11
SPEEDOMETER : System Description ...................11
TACHOMETER ...................................................... ....11
TACHOMETER : System Diagram .........................12
TACHOMETER : System De scription .....................12
ENGINE COOLANT TEMPERATURE GAUGE .... ....12
ENGINE COOLANT TEMPERATURE GAUGE :
System Diagram .................................................. ....
12
ENGINE COOLANT TEMPERATURE GAUGE :
System Description ............................................. ....
12
FUEL GAUGE ........................................................ ....12
FUEL GAUGE : System Diagram ............................12
FUEL GAUGE : System Description .......................12
MASTER WARNING LAMP ................................... ....12
MASTER WARNING LAMP : System Diagram .......13
MASTER WARNING LAMP : System Description ....13
METER ILLUMINATION CONTROL ..................... ....13
METER ILLUMINATION CONTROL : System Di-
agram .................................................................. ....
13
METER ILLUMINATION CONTROL : System De-
scription ............................................................... ....
13
METER EFFECT FUNCTION ................................ ....13
METER EFFECT FUNCTION : System Diagram ....14
METER EFFECT FUNCTION : System Descrip-
tion ....................................................................... ....
14
INFORMATION DISPLAY ...................................... ....15
INFORMATION DISPLAY : System Diagram ..........15
INFORMATION DISPLAY : System Description .....15
COMPASS ............................................................. ....16
COMPASS : Description ..........................................16
DIAGNOSIS SYSTEM (METER) .......................18
Description ........................................................... ....18
CONSULT Function (METER/M&A) ........................18
ECU DIAGNOSIS INFORMATION ..............22
COMBINATION METER ...................................22
Reference Value .................................................. ....22
Fail-Safe ..................................................................27
DTC Index ...............................................................27
BCM, IPDM E/R .................................................29
List of ECU Reference .............................................29
WIRING DIAGRAM ......................................30
COMPASS .........................................................30
Revision: November 20132014 Altima NAMRevision: November 20132014 Altima NAM