2005 TOYOTA AVENSIS Service Repair Manual

airbag USB port alternator air conditioning clutch technical specifications

Page 1417 of 5135

TOYOTA AVENSIS 2005 Service Repair Manual I35614
Wagon:
Engine Room R/B No.1
Engine Room J/B No.1
DCC FuseEngine Room R/B No.4 (*1)
Engine Room J/B No.4 (*1)
Engine Room R/B No.3 (*2)
ALT Fuse
Steering Pad Switch LHRadio Receiver Assy
Fro

Page 1418 of 5135

TOYOTA AVENSIS 2005 Service Repair Manual 0549J±12
± DIAGNOSTICSAUDIO SYSTEM
05±1405
AVENSIS REPAIR MANUAL (RM1018E)
DIAGNOSTIC TROUBLE CODE CHART
TermsMeaning
Physical addressThree±digit code (shown in hexadecimal) which is given to ea

0549J±12
± DIAGNOSTICSAUDIO SYSTEM
05±1405
AVENSIS REPAIR MANUAL (RM1018E)
DIAGNOSTIC TROUBLE CODE CHART
TermsMeaning
Physical addressThree±digit code (shown in hexadecimal) which is given to each component com-
prising the AVC±LAN.
Corresponding to the function, individual symbols are specified.
Logical addressTwo±digit code (shown in hexadecimal) which is given to each function comprising
the inner system of the AVC±LAN.
1. RADIO RECEIVER ASSY (Physical address: 190)
HINT:
*1: Even if no failure is detected, trouble code may be stored depending on the battery condition or
voltage for starting the engine.
*2: It is stored when 180 seconds have passed after the power supply connector is pulled out after the
engine starts.
*3: It may be stored when the engine key is turned 1 minuite after the engine starts.
*4: It may be stored when the engine key is turned again after the engine starts.
*5: When 210 seconds have passed after pulling out the power supply connector of the master compo-
nent with the ignition switch in ACC or ON, this code is stored.
(a) Logical address: 01 (Communication control)
DTCDiagnosis itemDescriptionAction to be taken
22RAM ErrorAbnormal condition of RAM is detected.Replace radio receiver assy.
D6
*1Absence of MasterComponent in which this code is recorded
was disconnected from system or master
component with ignition in ACC or ON.Check harness for power supply system of
radio receiver assy.
Check harness for communication system
of radio receiver assy.
D7
*5Connection check ErrorComponent in which this code is recorded
was disconnected from system or master
component ignition with in ACC or ON.Check harness for power supply of radio
receiver assy.
Check harness for communication system
of radio receiver assy.
D8
*2No Response to Connection CheckComponent shown by sub code is or was
disconnected from system after engine
start.Check harness for power supply system of
component shown by sub code.
Check harness for communication system
of component shown by sub code.
D9
*1Last Mode ErrorAudio or visual component operated before
engine stop is or was disconnected with
ignition switch in ACC or ON.Check harness for power supply system of
component shown by sub code.
Check harness for communication system
of component shown by sub code.
DANo Response to ON/OFF InstructionNo response is identified when changing
mode (audio and visual mode change).
Sound and picture does not change by but-
ton operation.Check harness for power supply system of
component shown by sub code.
Check harness for communication system
of component shown by sub code.
If error occurs again, replace component
shown by sub code.
DB
*1Mode Status ErrorDual alarm is detected.Check harness for power supply of compo-
nent shown by sub code.
Check harness for communication system
of component shown by sub code.
DC
*3Transmission ErrorTransmission to component shown by auxil-
iary code failed.
(Detecting this DTC does not necessarily
mean actual failure.)If same sub code is recorded in other com-
ponent, check harness for power supply and
communication system of all components
shown by code.
(If not, delete DTC and recheck.)

Page 1419 of 5135

TOYOTA AVENSIS 2005 Service Repair Manual 05±1406
± DIAGNOSTICSAUDIO SYSTEM
AVENSIS REPAIR MANUAL (RM1018E) DD
*4
Master Reset (Momentary Interruption)After the engine was started, master compo-
nent was disconnected from system.Check ha

05±1406
± DIAGNOSTICSAUDIO SYSTEM
AVENSIS REPAIR MANUAL (RM1018E) DD
*4
Master Reset (Momentary Interruption)After the engine was started, master compo-
nent was disconnected from system.Check harness for power supply system of
multi±display.
Check harness for communication system
of radio receiver assy.
If this error occurs frequently, replace radio
receiver assy.
DE
*4Slave Reset (Momentary Interruption)After the engine was started, component
shown by sub code had been disconnected
from system.Check harness for power supply of compo-
nent shown by sub code.
Check harness for communication system
of component shown by sub code.
E0
*1Registration Completion Instruction ErrorºRegistration Completion Instructionº com-
mand from master cannot be received.Since this DTC is provided for engineering
purpose, it may be detected when no actual
failure exists.
E2ON/OFF Instruction Parameter ErrorError occures in ON/OFF controlling com-
mand from master component.Replace radio receiver assy
E3
*1
Registration Request TransmissionRegistration Request command is output
from component shown by sub code.
Receiving Connection Check Instruction,
Registration Request command is output
from sub±master component.Since this DTC is provided for engineering
purpose, it may be detected when no actual
failure exists.
(b) Logical address: 61 (Cassette switch)
DTCDiagnosis itemDescriptionAction to be taken
40Mechanical Error of Media Malfunction due to mechanical failure is
identified.
Or cassette tape is cut or entangled.Inspect cassette tape.
Replace radio receiver assy.
41EJECT ErrorMalfunction due to mechanical failure.Replace radio receiver assy.
42Tape caught in the radio receiver assyHub lock etc.Inspect cassette tape.
(c) Logical address: 62 (CD player)
DTCDiagnosis itemDescriptionAction to be taken
42No Disc ReadoutDisc cannot be read.Inspect CD.
Replace radio receiver assy.
44CD player ErrorError is detected in CD player.Replace radio receiver assy.
45EJECT ErrorMagazine cannot be ejected.Replace radio receiver assy.
46Scratched/Reversed DiscScratches or dirt is found on CD surface or
CD is set upside down.Inspect CD.
47CD High Temp.High temperature is detected in CD player.Replace radio receiver assy.
48CD Excess CurrentExcess current is applied CD player.Replace radio receiver assy.

Page 1420 of 5135

TOYOTA AVENSIS 2005 Service Repair Manual 0549I±12
I35610
1
6
DISC
SEEK UPSEEK DOWN
± DIAGNOSTICSAUDIO SYSTEM
05±1399
AVENSIS REPAIR MANUAL (RM1018E)
PRE±CHECK
1. DIAGNOSIS CHECK
(a) Starting Diagnosis Mode (All elements are lighting in

Page 1421 of 5135

TOYOTA AVENSIS 2005 Service Repair Manual 05±1400
± DIAGNOSTICSAUDIO SYSTEM
AVENSIS REPAIR MANUAL (RM1018E)
(d) Service Check Mode Result Display (for checking the cur-
rent and the past system conditions).
(1) Press the ºSEEK TRACKº sw

Page 1422 of 5135

TOYOTA AVENSIS 2005 Service Repair Manual ± DIAGNOSTICSAUDIO SYSTEM
05±1401
AVENSIS REPAIR MANUAL (RM1018E) DisplayAction to be taken Meaning Original Language
OLDOld versionOld DTC application is identified and DTC is detected in ei-
the

Page 1423 of 5135

TOYOTA AVENSIS 2005 Service Repair Manual I34695
Service Check Mode
Detail Information ModePRESET SWITCH º3º
PRESET SWITCH º2º
Detail information
of the first code
is displayed
Detail information
of the second code
is displayed
Continue t

Page 1424 of 5135

TOYOTA AVENSIS 2005 Service Repair Manual ± DIAGNOSTICSAUDIO SYSTEM
05±1403
AVENSIS REPAIR MANUAL (RM1018E)
(3) Displayed Items in Detailed Information Mode
Division Code for
DTC displayMeaning
The order of detailed information displayed

Load next 8 pages

Page: < prev 1-10 ... 1385-1392 1393-1400 1401-1408 1409-1416 1417-1424 1425-1432 1433-1440 1441-1448 1449-1456 ... 5136 next >

ECU open hood windshield wipers adblue gearbox jacking points