2003 NISSAN TEANA Service Manual

check transmission fluidmaintenance schedulehigh beamair conditionweightbrake light
Popular search:
change key batteryReverseclimate controlOBD portGI-10remote startbattery replacement
Previous
Next
Load previous 8 pages

Page 1457 of 3502

NISSAN TEANA 2003 Service Manual DTC P0335 CKP SENSOR (POS) EC-175 [QR] C D E F G H I J K L MA EC 4. Visually check the sensor for chipping. 5. Check resistance as shown in the figure. 6. If NG, replace crankshaft position sensor (

Page 1458 of 3502

NISSAN TEANA 2003 Service Manual EC-176 [QR] DTC P0340 CMP SENSOR (PHASE) DTC P0340 CMP SENSOR (PHASE)PFP:23731 Component DescriptionBBS005EO The camshaft position sensor (PHASE) senses the retraction of camshaft (intake) to identi

Page 1459 of 3502

NISSAN TEANA 2003 Service Manual DTC P0340 CMP SENSOR (PHASE) EC-177 [QR] C D E F G H I J K L MA EC DTC Confirmation ProcedureBBS005ER NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch O

Page 1460 of 3502

NISSAN TEANA 2003 Service Manual EC-178 [QR] DTC P0340 CMP SENSOR (PHASE) Wiring DiagramBBS005ES TBWM1488E

Page 1461 of 3502

NISSAN TEANA 2003 Service Manual DTC P0340 CMP SENSOR (PHASE) EC-179 [QR] C D E F G H I J K L MA EC Specification data are reference values and are measured between each terminal and ground. Pulse signal is measured by CONSULT-II.

Page 1462 of 3502

NISSAN TEANA 2003 Service Manual EC-180 [QR] DTC P0340 CMP SENSOR (PHASE) 2. CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Loosen and retighten two ground screws on the body. Refer to E C - 111 , " Ground Inspection" .

Page 1463 of 3502

NISSAN TEANA 2003 Service Manual DTC P0340 CMP SENSOR (PHASE) EC-181 [QR] C D E F G H I J K L MA EC 5. CHECK CMP SENSOR (PHASE) GROUND CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect ECM harness connector. 3.

Page 1464 of 3502

NISSAN TEANA 2003 Service Manual EC-182 [QR] DTC P0340 CMP SENSOR (PHASE) Component InspectionBBS005EU CAMSHAFT POSITION SENSOR (PHASE) 1. Loosen the fixing bolt of the sensor. 2. Disconnect camshaft position sensor (PHASE) harness
Load next 8 pages
Page:   < prev 1-10 ... 1425-1432 1433-1440 1441-1448 1449-1456 1457-1464 1465-1472 1473-1480 1481-1488 1489-1496 ... 3504 next >
adding oilnight visionheadlight bulbbonnetoverheatingfour wheel drive
Popular search:
Front covertraction controlmileageLight bulbSymbolstiming chain installationchild lock