Page 2089 of 3502

BODY SIDE TRIM
EI-41
C
D
E
F
G
H
J
K
L
MA
B
EI
2. Remove kicking plate inner mounting clips using a clip clamp
remover, and then remove kicking plate inner.
Installation
Install in the reverse order of removal.
REAR BODY SIDE WELT
Removal
1. Remove center pillar lower garnish.
2. Remove rear seat cushion. Refer to SE-112, "
REAR SEAT" .
3. Remove rear kicking plate inner.
4. Remove rear body side welt.
Installation
Install in the reverse order of removal.
REAR SEATBACK FINISHER
Removal
1. Remove rear seat cushion and rear seatback. Refer to SE-112,
"REAR SEAT" .
2. Remove rear seat belt floor anchor bolt. Refer to SB-5,
"Removal and Installation of Rear Seat Belt" .
3. Remove rear kicking plate inner.
4. Remove rear seatback finisher.
Installation
Install in the reverse order of removal.
NOTE:
To install, check if all clips are matched over holes of panel on vehicle, then push on.
REAR PILLAR FINISHER
Removal
1. Remove rear seat cushion and rear seatback. Refer to SE-112,
"REAR SEAT" .
2. Remove rear seat belt floor anchor bolt. Refer to SB-5,
"Removal and Installation of Rear Seat Belt" .
3. Remove rear kicking plate inner.
4. Remove rear seatback finisher.
5. Remove pillar finisher mounting clips using a screwdriver, and
then remove pillar finisher.
PIIA7074E
PIIA7075E
PIIA7076E
Page 2090 of 3502
EI-42
BODY SIDE TRIM
CAUTION:
Insert a clip clamp remover wrapped with a shop cloth or
clip clamp remover into the part shown by the arrow
(between the clips and the body side panel). Remove clips.
Installation
Install in the reverse order of removal.
CAUTION:
Make sure that clips are securely fitted in panel holes on body when installing, and then press them in.
SIIA0810E
Page 2091 of 3502
REAR PARCEL SHELF FINISHER
EI-43
C
D
E
F
G
H
J
K
L
MA
B
EI
REAR PARCEL SHELF FINISHERPFP:79910
Removal and InstallationB I S 0 0 11T
PIIA9529E
1. Rear parcel shelf finisher (standard) 2. Clip (C106) 3.Rear seat belt shoulder anchor cover
(center)
4. Rear speaker grille (for woofer) 5.High-mounted stop lamp harness
connector6. High-mounted stop lamp
Page 2092 of 3502

EI-44
REAR PARCEL SHELF FINISHER
REMOVAL
1. Remove rear seatback and rear seat cushion. Refer to SE-112, "REAR SEAT" .
2. Remove rear seat belt floor anchor bolt and rear seat belt shoulder anchor bolt. Refer to SB-5, "
Removal
and Installation of Rear Seat Belt" .
3. Disengage child anchor cover front pawls, and then pull out child
anchor cover (LH/RH center) toward front of vehicle.(Models
with rear window sunshade)
4. Remove rear kicking plate inner, rear seatback finisher, rear pillar finisher. Refer to EI-38, "
BODY SIDE
TRIM" .
5. Disconnect high-mounted stop lamp harness connector from
trunk room side. (Models without rear window sunshade)
6. Disconnect high-mounted stop lamp harness connector from
front side of rear parcel shelf finisher. (Models with rear window
sunshade)
7. Remove rear parcel shelf finisher mounting clip using a clip clamp remover.
8. Remove rear parcel shelf finisher while disengaging dual-lock fastener on back of rear parcel shelf fin-
isher. (Models with rear window sunshade)
9. Remove the following parts after removing rear parcel shelf finisher.
Rear speaker grille (for woofer)
High-mounted stop lamp
INSTALLATION
Install in the reverse order of removal.
7. Screw 8.Rear parcel shelf finisher (with sun-
shade)9. Child anchor cover (LH/RH center)
10. Rear window sunshade 11. Bolt 12. Locating pin
PIIA9530E
PIIA9531E
PIIA9535E
Page 2093 of 3502
REAR PARCEL SHELF FINISHER
EI-45
C
D
E
F
G
H
J
K
L
MA
B
EI
REAR WINDOW SUNSHADE
Removal
1. Remove rear parcel shelf finisher. Refer to EI-43, "REAR PARCEL SHELF FINISHER" .
2. Disconnect rear window sunshade harness connector.
3. Remove rear window sunshade mounting bolts.
4. Lift up rear window sunshade and pull out locating pin from body side panel hole, and then remove rear
window sunshade.
Installation
Install in the reverse order of removal.
PIIA9536E
Page 2094 of 3502
EI-46
SUNSHADE
SUNSHADEPFP:97580
Component Parts and Harness Connector LocationBIS0011U
1. Rear sunshade front switch
M172. Rear sunshade rear switch
B1723. Rear sunshade (Open condition)
B172
4. Rear sunshade (Close condition)
B172
PIIB8829E
Page 2095 of 3502
SUNSHADE
EI-47
C
D
E
F
G
H
J
K
L
MA
B
EI
Wiring Diagram — SHADE —/For A/T ModelsBIS0011V
TIWM1771E
Page 2096 of 3502