2003 NISSAN TEANA Service Manual

clocknavigation updatebattery locationinterior lightsgarage door openerengine oil
Popular search:
trip computerwheel bolt torquetrunkmirroralarmtraction controlfuel tank removal
Previous
Next
Load previous 8 pages

Page 353 of 3502

NISSAN TEANA 2003 Service Manual ASSEMBLY AT-345 D E F G H I J K L MA B AT 4. Measure dimensions “1 ” and “2 ” at side cover and then cal- culate dimension “A”. Measure dimension “ 1” and “ 2” in at least two p

Page 354 of 3502

NISSAN TEANA 2003 Service Manual AT-346 ASSEMBLY 3. Tighten side cover fitting bolts to specified torque. Refer to AT- 246, "Components" . CAUTION: Do not mix bolts A and B. Always replace bolts A as they are self-sealing bolts.

Page 355 of 3502

NISSAN TEANA 2003 Service Manual ASSEMBLY AT-347 D E F G H I J K L MA B AT 7. Install overrun clutch hub. CAUTION: Align teeth of overrun clutch before install. 8. Check operation of forward one-way clutch. CAUTION: Hold rear inte

Page 356 of 3502

NISSAN TEANA 2003 Service Manual AT-348 ASSEMBLY b. Install rear sun gear on rear planetary carrier. CAUTION: Be careful to direction of rear sun gear. c. Install rear planetary carrier (with rear sun gear) on transaxle case. 11. I

Page 357 of 3502

NISSAN TEANA 2003 Service Manual ASSEMBLY AT-349 D E F G H I J K L MA B AT c. Install low & reverse brake piston and retainer on transaxle case. CAUTION: Align bracket to specified gutter as indicated in figure. d. Make sure that e

Page 358 of 3502

NISSAN TEANA 2003 Service Manual AT-350 ASSEMBLY 14. Install snap ring with flat-bladed screwdriver. CAUTION: Forward clutch and bearing must be correctly installed for snap ring to fit into groove of transaxle case. 15. Install fr

Page 359 of 3502

NISSAN TEANA 2003 Service Manual ASSEMBLY AT-351 D E F G H I J K L MA B AT b. Install high clutch hub on front sun gear. 17. Install input shaft assembly (high clutch assembly) according to the following procedures. a. Install need

Page 360 of 3502

NISSAN TEANA 2003 Service Manual AT-352 ASSEMBLY 18. Install reverse clutch assembly on input shaft assembly (high clutch drum). Adjustment (2)BCS001OZ When any parts listed below are replaced, adjust total end play and reverse clu
Load next 8 pages
Page:   < prev 1-10 ... 321-328 329-336 337-344 345-352 353-360 361-368 369-376 377-384 385-392 ... 3504 next >
lumbar supportreset sun roofnavigationgas mileagetiming beltcharging
Popular search:
batteryground clearancePowertow barodometerdiagnostic menuparking brake