2003 NISSAN TEANA Service Manual

flat tire air conditioning fuse chart low oil pressure dimensions service interval

Load previous 8 pages

Page 225 of 3502

NISSAN TEANA 2003 Service Manual A/T SHIFT LOCK SYSTEM
AT-217
D
E
F
G
H
I
J
K
L
MA
B
AT

Wiring Diagram — AT — SHIFTBCS00151
WITHOUT INTELLIGENT KEY
TCWM0523E

Page 226 of 3502

NISSAN TEANA 2003 Service Manual AT-218
A/T SHIFT LOCK SYSTEM

TCWM0524E

Page 227 of 3502

NISSAN TEANA 2003 Service Manual A/T SHIFT LOCK SYSTEM
AT-219
D
E
F
G
H
I
J
K
L
MA
B
AT

WITH INTELLIGENT KEY
TCWM0525E

Page 228 of 3502

NISSAN TEANA 2003 Service Manual AT-220
A/T SHIFT LOCK SYSTEM

TCWM0526E

Page 229 of 3502

NISSAN TEANA 2003 Service Manual A/T SHIFT LOCK SYSTEM
AT-221
D
E
F
G
H
I
J
K
L
MA
B
AT

Shift Lock Control Unit Reference ValuesBCS00152
SHIFT LOCK HARNESS CONNECTOR TERMINALS LAYOUT
SHIFT LOCK CONTROL UNIT INSPECTION TABLE
Data ar

A/T SHIFT LOCK SYSTEM
AT-221
D
E
F
G
H
I
J
K
L
MA
B
AT

Shift Lock Control Unit Reference ValuesBCS00152
SHIFT LOCK HARNESS CONNECTOR TERMINALS LAYOUT
SHIFT LOCK CONTROL UNIT INSPECTION TABLE
Data are reference values.
NOTE:
Make sure that the pointer swings only momentarily because the output time is so short. If the inspection is done with an oscilloscope, it
should be observed that the power source voltage lasts for 3.5 to 10 ms.
SCIA2004E
Terminal Wire color Item Condition Judgement standard
1 Y/R Power source Always Battery voltage
2LDetention switch (for
key)When selector lever is not in “P” position with
key inserted.Battery voltage
When selector lever is in “P” position with key
inserted.Approx. 0 V
3RDetention switch (for
shift)When selector lever is not “P” position. Battery voltage
When selector lever is “P” position. Approx. 0 V
4 R/G Stop lamp switchWhen brake pedal is depressed Battery voltage
When brake pedal is released Approx. 0 V
5V/WVehicle speed signal
(8pulse signal)Speed meter is operatedRefer to DI-12, "
Terminals and Ref-
erence Value for Combination
Meter" .
6 G Ignition switch signalIgnition switch: OFF Approx. 0 V
Ignition switch: ON Battery voltage
7 R/W Shift lock solenoid
When selector lever is in “P” position, brake
pedal is depressed, and ignition switch is ON.
When selector lever is not in “P” position,
ignition switch is ON, and vehicle speed is
10km/h or less.
For 3minutes after selector lever is not in “P”
position, vehicle speed is 10 km/h or less,
and ignition switch is ON → OFF.Approx. 0 V
Except the above Battery voltage
8 B Ground Always Approx. 0 V
9 G/B Key lock solenoidWhen selector lever is not “P” position.Battery voltage for approx. 0.1 sec.
(Note)
When selector lever is “P” position. Approx. 0 V
10 G/WKey unlock solenoidWhen selector lever is “P” position with ignition
switch is OFF.Battery voltage for approx. 0.1 sec.
(Note)
When selector lever is not “P” position with igni-
tion switch is OFF.Approx. 0 V

Page 230 of 3502

NISSAN TEANA 2003 Service Manual AT-222
A/T SHIFT LOCK SYSTEM

Component InspectionBCS00153
SHIFT LOCK SOLENOID
Check operation by applying battery voltage to A/T device harness
connector terminal.
CAUTION:
Be sure to apply the volt

Page 231 of 3502

NISSAN TEANA 2003 Service Manual A/T SHIFT LOCK SYSTEM
AT-223
D
E
F
G
H
I
J
K
L
MA
B
AT

Key Lock (Without Intelligent Key)
Check operation by applying battery voltage to key switch and key
lock solenoid harness connector terminal.

Page 232 of 3502

NISSAN TEANA 2003 Service Manual AT-224
A/T SHIFT LOCK SYSTEM

IGNITION KNOB SWITCH (WITH INTELLIGENT KEY)
Check continuity between terminals of ignition knob switch, key
switch and key lock solenoid harness connector.
STOP LAMP SWI

Load next 8 pages

Page: < prev 1-10 ... 193-200 201-208 209-216 217-224 225-232 233-240 241-248 249-256 257-264 ... 3504 next >

clock service indicator tyre pressure parking sensors remote start OBD port