Page 209 of 3641
![NISSAN NOTE 2016 Service Repair Manual AV-204
< DTC/CIRCUIT DIAGNOSIS >[NAVIGATION]
U1258 SATELLITE RADIO ANTENNA
U1258 SATELLITE RADIO ANTENNA
DTC LogicINFOID:0000000012433064
DTC DETECTION LOGIC
Diagnosis ProcedureINFOID:0000000012433065 NISSAN NOTE 2016 Service Repair Manual AV-204
< DTC/CIRCUIT DIAGNOSIS >[NAVIGATION]
U1258 SATELLITE RADIO ANTENNA
U1258 SATELLITE RADIO ANTENNA
DTC LogicINFOID:0000000012433064
DTC DETECTION LOGIC
Diagnosis ProcedureINFOID:0000000012433065](/manual-img/5/57363/w960_57363-208.png)
AV-204
< DTC/CIRCUIT DIAGNOSIS >[NAVIGATION]
U1258 SATELLITE RADIO ANTENNA
U1258 SATELLITE RADIO ANTENNA
DTC LogicINFOID:0000000012433064
DTC DETECTION LOGIC
Diagnosis ProcedureINFOID:0000000012433065
Regarding Wiring Diagram information, refer to
AV-155, "Wiring Diagram".
1.SATELLITE ANTENNA INSPECTION
Visually inspect the satellite antenna and antenna feeder. Refer to AV-256, "
Feeder Layout".
Is inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace malfunctioning components.
2.CHECK AV CONTROL UNIT VOLTAGE
1. Turn ignition switch ON.
2. Check voltage between AV control unit connector M111 and ground.
Is inspection result normal?
YES >> Replace satellite radio antenna AV-254, "Removal and Installation".
NO >> Replace AV control unit. Refer to AV-241, "
Removal and Installation".
CONSULT DisplayDTC Detection Condition Possible Cause
XM ANTENNA CONN
[U1258] Open or short to ground is detected in satellite
antenna connection. • Satellite antenna disconnection.
• Open or short to ground in satellite antenna
signal circuit.
AV control unit GroundVoltage
Connector Terminal
M 111 5 7—5 . 0 V
Revision: August 2015 2016 Versa Note
cardiagn.com
Page 210 of 3641
![NISSAN NOTE 2016 Service Repair Manual AV
U1263 USBAV-205
< DTC/CIRCUIT DIAGNOSIS > [NAVIGATION]
C
D
E
F
G H
I
J
K L
M B A
O P
U1263 USB
DTC LogicINFOID:0000000012433066
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM SELF DIAGNOS NISSAN NOTE 2016 Service Repair Manual AV
U1263 USBAV-205
< DTC/CIRCUIT DIAGNOSIS > [NAVIGATION]
C
D
E
F
G H
I
J
K L
M B A
O P
U1263 USB
DTC LogicINFOID:0000000012433066
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM SELF DIAGNOS](/manual-img/5/57363/w960_57363-209.png)
AV
U1263 USBAV-205
< DTC/CIRCUIT DIAGNOSIS > [NAVIGATION]
C
D
E
F
G H
I
J
K L
M B A
O P
U1263 USB
DTC LogicINFOID:0000000012433066
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM SELF DIAGNOSTIC RESULT
1. If there is a device connected to the USB interface, disconnect it.
2. Turn ignition switch ON and wait for 2 seconds or more.
3. Perform Self Diagnostic Result for MULTI AV.
Is DTC U1263 displayed?
YES >> Refer to AV-205, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis ProcedureINFOID:0000000012433067
1.CHECK USB INTERFACE HARNESS
Visually inspect USB interface harness. Refer to AV-245, "
Removal and Installation".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Replace USB interface harness. Refer to AV-245, "
Removal and Installation".
2.CHECK USB INTERFACE HARNESS
Check USB interface harness. Refer to AV-226, "
Diagnosis Procedure".
Is the inspection result normal?
YES >> Replace AV control unit. Refer to AV-241, "Removal and Installation".
NO >> Replace USB interface harness. Refer to AV-245, "
Removal and Installation".
CONSULT Display DTC Detection Condition Possible Cause
USB OVERCURRENT
[U1263] Overcurrent in USB harness is detected. • Device connected to USB interface.
• Harness between the AV control unit and USB
interface.
Revision: August 2015 2016 Versa Note
cardiagn.com
Page 211 of 3641
![NISSAN NOTE 2016 Service Repair Manual AV-206
< DTC/CIRCUIT DIAGNOSIS >[NAVIGATION]
U1264 ANTENNA AMP.
U1264 ANTENNA AMP.
DTC LogicINFOID:0000000012433068
DTC DETECTION LOGIC
Diagnosis ProcedureINFOID:0000000012433069
Regarding Wiring Diag NISSAN NOTE 2016 Service Repair Manual AV-206
< DTC/CIRCUIT DIAGNOSIS >[NAVIGATION]
U1264 ANTENNA AMP.
U1264 ANTENNA AMP.
DTC LogicINFOID:0000000012433068
DTC DETECTION LOGIC
Diagnosis ProcedureINFOID:0000000012433069
Regarding Wiring Diag](/manual-img/5/57363/w960_57363-210.png)
AV-206
< DTC/CIRCUIT DIAGNOSIS >[NAVIGATION]
U1264 ANTENNA AMP.
U1264 ANTENNA AMP.
DTC LogicINFOID:0000000012433068
DTC DETECTION LOGIC
Diagnosis ProcedureINFOID:0000000012433069
Regarding Wiring Diagram information, refer to
AV-155, "Wiring Diagram".
1.ANTENNA AMP. INSPECTION
Visually inspect the antenna base ( antenna amp.) and antenna feeder. Refer to AV-256, "
Feeder Layout".
Is inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace malfunctioning components.
2.CHECK CONTINUITY BETWEEN AV CONTROL UNIT AND ANTENNA BASE
1. Turn ignition switch OFF.
2. Disconnect AV control unit connector M73 and antenna base connector M351.
3. Check continuity between AV control unit connector M73 and antenna base connector M351.
4. Check continuity between AV control unit connector M73 and ground.
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace harness or connectors.
3.CHECK AV CONTROL UNIT VOLTAGE
1. Connect AV control unit connector M73.
2. Turn ignition switch ON.
3. Check voltage between AV control unit connector M73 and ground.
Is the inspection result normal?
YES >> Replace antenna base. Refer to AV-255, "Removal and Installation".
NO >> Replace AV control unit. Refer to AV-241, "
Removal and Installation".
CONSULT DisplayDTC Detection Condition Possible Cause
ANTENNA AMP TERMINAL
[U1264] Open or short to ground is detected in Antenna
amp. connection. • Antenna amp. disconnection.
• Open or short to ground in antenna amp. ON
signal circuit.
AV control unit Antenna base
Continuity
Connector TerminalConnector Terminal
M 735 0M35 11 Y es
AV control unit
Ground Continuity
Connector Terminal
M73 50—No
AV control unit
GroundVo l ta g e
(Approx.)
Connector Terminal
M73 50—Battery voltage
Revision: August 2015 2016 Versa Note
cardiagn.com
Page 212 of 3641
AV
U12AA CONFIGURATION ERRORAV-207
< DTC/CIRCUIT DIAGNOSIS > [NAVIGATION]
C
D
E
F
G H
I
J
K L
M B A
O P
U12AA CONFIGURATION ERROR
DTC LogicINFOID:0000000012433070
DTC DETECTION LOGIC
Diagnosis ProcedureINFOID:0000000012433071
1.PERFORM CONFIGURATION
When U12AA is detected, configuration data must be written.
>> Write configuration data with CONSULT. Refer to AV-175, "
CONFIGURATION (AV CONTROL
UNIT) : Work Procedure".
CONSULT DisplayDTC Detection Condition Possible Cause
Configuration Error
[U12AA] AV control unit is not properly configured or con-
figuration is corrupt. Configuration data needs to be written.
Refer to AV- 1 7 5 , "
CONFIGURATION (AV CON-
TROL UNIT) : Work Procedure".
Revision: August 2015
2016 Versa Note
cardiagn.com
Page 213 of 3641
AV-208
< DTC/CIRCUIT DIAGNOSIS >[NAVIGATION]
U12AC AV CONTROL UNIT
U12AC AV CONTROL UNIT
DTC LogicINFOID:0000000012433072
DTC DETECTION LOGIC
CONSULT Display
DTC Detection Condition Possible Cause
Display Temperature too High
[U12AC] Display temperature has exceeded maximum
temperature. Display is switched OFF to avoid ir-
reversible damage. Replace AV control unit if malfunction occurs
constantly.
Refer to AV- 2 4 1 , "
Removal and Installation".
Revision: August 2015
2016 Versa Note
cardiagn.com
Page 214 of 3641
AV
U12AD AV CONTROL UNITAV-209
< DTC/CIRCUIT DIAGNOSIS > [NAVIGATION]
C
D
E
F
G H
I
J
K L
M B A
O P
U12AD AV CONTROL UNIT
DTC LogicINFOID:0000000012433073
DTC DETECTION LOGIC
CONSULT Display DTC Detection Condition Possible Cause
ECU Temperature too High
[U12AD] AV control unit temperature has exceeded maxi-
mum temperature. Replace AV control unit if malfunction occurs
constantly.
Refer to
AV- 2 4 1 , "
Removal and Installation".
Revision: August 2015 2016 Versa Note
cardiagn.com
Page 215 of 3641
AV-210
< DTC/CIRCUIT DIAGNOSIS >[NAVIGATION]
U12AE AV CONTROL UNIT
U12AE AV CONTROL UNIT
DTC LogicINFOID:0000000012433074
DTC DETECTION LOGIC
CONSULT Display
DTC Detection Condition Possible Cause
Internal Amplifier temperature
Warning
[U12AE] Internal amplifier temperature has exceeded
maximum temperature. Replace AV control unit if malfunction occurs
constantly.
Refer to AV- 2 4 1 , "
Removal and Installation".
Revision: August 2015
2016 Versa Note
cardiagn.com
Page 216 of 3641
AV
U12AF AV CONTROL UNITAV-211
< DTC/CIRCUIT DIAGNOSIS > [NAVIGATION]
C
D
E
F
G H
I
J
K L
M B A
O P
U12AF AV CONTROL UNIT
DTC LogicINFOID:0000000012433075
DTC DETECTION LOGIC
CONSULT Display DTC Detection Condition Possible Cause
CD Mechanism Temperature
Warning
[U12AF] CD drive temperature has exceeded maximum
temperature. CD drive is switched OFF to avoid
irreversible
damage. Replace AV control unit if malfunction occurs
constantly.
Refer to
AV- 2 4 1 , "
Removal and Installation".
Revision: August 2015 2016 Versa Note
cardiagn.com