2004 INFINITI FX35 Service Manual

trunk trailer dead battery open trunk water pump hood release wheel

Load previous 8 pages

Page 65 of 4449

INFINITI FX35 2004 Service Manual ACS-56
[ICC]
TROUBLE DIAGNOSIS FOR SELF-DIAGNOSTIC ITEMS
Revision: 2004 November 2004 FX35/FX45
4. CHECK SHIFT POSITION SIGNAL
With CONSULT-II
With TCM diagnosis, check that shift operates normally.

Page 66 of 4449

INFINITI FX35 2004 Service Manual TROUBLE DIAGNOSIS FOR SELF-DIAGNOSTIC ITEMS
ACS-57
[ICC]
C
D
E
F
G
H
I
J
L
MA
B
ACS
Revision: 2004 November 2004 FX35/FX45
4. CHECK TCM GEAR POSITION SIGNAL
With CONSULT-II
With TCM data monitor wi

Page 67 of 4449

INFINITI FX35 2004 Service Manual ACS-58
[ICC]
TROUBLE DIAGNOSIS FOR SELF-DIAGNOSTIC ITEMS
Revision: 2004 November 2004 FX35/FX45
DTC 103 LASER SENSOR FAILAKS006ZJ
1. DIAGNOSTIC CHECK
Are “DTC 11 CONTROL UNIT” or “DTC 20 CAN C

Page 68 of 4449

INFINITI FX35 2004 Service Manual TROUBLE DIAGNOSIS FOR SYMPTOMS
ACS-59
[ICC]
C
D
E
F
G
H
I
J
L
MA
B
ACS
Revision: 2004 November 2004 FX35/FX45
TROUBLE DIAGNOSIS FOR SYMPTOMSPFP:00007
Symptom ChartAKS006ZN
Symptoms Reference page
Oper

Page 69 of 4449

INFINITI FX35 2004 Service Manual ACS-60
[ICC]
TROUBLE DIAGNOSIS FOR SYMPTOMS
Revision: 2004 November 2004 FX35/FX45
Symptom 1: ON/OFF Switch Does Not Switch ON*1 . ON/OFF Switch Does Not
Switch OFF
*2 .AKS006ZO
NOTE:
*1:The ICC sys

Page 70 of 4449

INFINITI FX35 2004 Service Manual TROUBLE DIAGNOSIS FOR SYMPTOMS
ACS-61
[ICC]
C
D
E
F
G
H
I
J
L
MA
B
ACS
Revision: 2004 November 2004 FX35/FX45
2. PERFORM SELF-DIAGNOSIS
With CONSULT-II
1. Perform CONSULT-II self-diagnosis to check f

Page 71 of 4449

INFINITI FX35 2004 Service Manual ACS-62
[ICC]
TROUBLE DIAGNOSIS FOR SYMPTOMS
Revision: 2004 November 2004 FX35/FX45
Symptom 4: The ICC System Is Not Cancelled When the Gear Is in Other Than
‘D’.
AKS006ZR
1. CHECK D RANGE SWITCH

ACS-62
[ICC]
TROUBLE DIAGNOSIS FOR SYMPTOMS
Revision: 2004 November 2004 FX35/FX45
Symptom 4: The ICC System Is Not Cancelled When the Gear Is in Other Than
‘D’.
AKS006ZR
1. CHECK D RANGE SWITCH
With CONSULT-II
1. With data monitor, check that “D RANGE SW” operates normally.Refer to ACS-32, "
DATA MONITOR" .
OK or NG
OK >> After replacing ICC unit, erase DTC. Perform ICC system running test, and then perform self-diag-
nosis of ICC system again.
NG >> GO TO 2.
2. CHECK CAN COMMUNICATION
With CONSULT-II
1. With CONSULT-II self-diagnosis, check that “CAN COMM CIRCUIT” item exists.
OK or NG
OK >> GO TO 3.
NG >> Refer to ACS-41, "
DTC 20 CAN COMM CIRCUIT" .
3. CHECK D RANGE SWITCH
1. With TCM data monitor, check that “D” position switch operates normally.
OK or NG
OK >> After replacing ICC unit. Perform ICC system running test, and then perform self-diagnosis of ICC
system again.
NG >> After repairing or replacing malfunctioning part. Perform ICC system running test, and then per-
form self-diagnosis of ICC system again.
Symptom 5: Chime Does Not Sound.AKS006ZS
The chime may not sound occasionally in the following cases even if the distance from the vehicle ahead is
short:
When the speed difference from that of the vehicle ahead is small (both vehicles driving at similar speed).
When the vehicle ahead drives at faster speed (the actual distance is increasing).
When depressing the accelerator.
Chime does not sound when the vehicle is not driving.
Chime does not sound when the system does not detect any vehicle ahead. (Diagnose the conditions
under which the system is detecting the vehicle ahead and when the system is malfunctioning. If there is
any malfunction in detecting the vehicle ahead, check the system following the ACS-63, "
Symptom 7: The
ICC System Frequently Cannot Detect the Vehicle Ahead/The Detection Zone Is Short." .
1. CHECK ICC WARNING CHIME
With CONSULT-II
1. With active test, check that ICC warning chime operates normally.
OK or NG
OK >> Determine preceding vehicle detection status when malfunction occurred. If chime should have
sounded: after replacing ICC unit. Perform ICC system running test, and then perform self-diag-
nosis of ICC system again.
NG >> GO TO 2.

Page 72 of 4449

INFINITI FX35 2004 Service Manual TROUBLE DIAGNOSIS FOR SYMPTOMS
ACS-63
[ICC]
C
D
E
F
G
H
I
J
L
MA
B
ACS
Revision: 2004 November 2004 FX35/FX45
2. CAN COMMUNICATION INSPECTION
With CONSULT-II
1. With CONSULT-II self-diagnosis, check

TROUBLE DIAGNOSIS FOR SYMPTOMS
ACS-63
[ICC]
C
D
E
F
G
H
I
J
L
MA
B
ACS
Revision: 2004 November 2004 FX35/FX45
2. CAN COMMUNICATION INSPECTION
With CONSULT-II
1. With CONSULT-II self-diagnosis, check that “CAN COMM CIRCUIT” item exists.
OK or NG
OK >> Refer to ACS-41, "DTC 20 CAN COMM CIRCUIT" .
NG >> After replacing combination meter, erase DTC. Perform ICC system running test, and then per-
form self-diagnosis of ICC system again.
Symptom 6: Driving Force Is Hunting.AKS006ZU
1. CHECK ECM
1. Perform self-diagnosis of ECM.
OK or NG
OK >> Refer toACS-63, "Symptom 7: The ICC System Frequently Cannot Detect the Vehicle Ahead/The
Detection Zone Is Short." .
NG >> After repairing applicable parts, erase DTC. Perform ICC system running test, and then perform
self-diagnosis of ICC system again.
Symptom 7: The ICC System Frequently Cannot Detect the Vehicle Ahead/The
Detection Zone Is Short.
AKS006ZV
The detection function may become unstable in the following cases:
When the reflector of the vehicle ahead is deficient/ not clean enough to reflect the radar.
When driving a road with extremely sharp corners.
When the radar cannot detect the reflector of the vehicle ahead as the vehicle ahead is passing a hill or
passing the peak.
1. VISUAL CHECK
1. Check ICC sensor body window for contamination and foreign materials.
OK or NG
OK >> If any contamination or foreign materials are found, remove them. Then perform ICC system run-
ning test.
NG >> GO TO 2.
2. CHECK FUNCTION
1. After adjusting ICC sensor beam aiming, perform ICC system running test. Check that preceding vehicle
detection performance has been improved.
OK or NG
OK >> INSPECTION END
NG >>
Replace ICC sensor, and perform laser beam aiming adjustment.
After performing above. Perform ICC system running test, and then perform self-diagnosis of
ICC system again.
Symptom 8: The System Does Not Detect the Vehicle Ahead at All.AKS006ZW
1. VISUAL CHECK
1. With ignition switch turned ON (engine not started), check that all indicator lamps in ICC system display
are continuously lit. (Check for a missing segment in preceding vehicle detection display.)
OK or NG
OK >> GO TO 2.
NG >> Check for combination meter. Refer to DI-13, "
How to Proceed With Trouble Diagnosis" in DI.

Load next 8 pages

Page: < prev 1-10 ... 33-40 41-48 49-56 57-64 65-72 73-80 81-88 89-96 97-104 ... 4456 next >

fuel cap release tow coolant brake light trailer coolant capacity