2001 CHRYSLER VOYAGER Service Manual

gas type fuel tank removal deactivate airbag bolt pattern mirror drain bolt

Load previous 8 pages

Page 169 of 4284

CHRYSLER VOYAGER 2001 Service Manual TEST ACTION APPLICABILITY
3NOTE: Ensure that the battery is fully charged.
WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS DROPPED
AT ANY TIME, IT MUST BE REPLACED.
WARNING: TURN IGNITION OFF, DISCON

Page 170 of 4284

CHRYSLER VOYAGER 2001 Service Manual Symptom:
ORC, PASSENGER SBT CIRCUIT OPEN - ACTIVE
When Monitored and Set Condition:
ORC, PASSENGER SBT CIRCUIT OPEN - ACTIVE
When Monitored: When the ignition is On, the ORC monitors the resistance of

Page 171 of 4284

CHRYSLER VOYAGER 2001 Service Manual TEST ACTION APPLICABILITY
2WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger SBT.
Disconnect the Occupant Restraint Controller Connect

TEST ACTION APPLICABILITY
2WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger SBT.
Disconnect the Occupant Restraint Controller Connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the SRS load tool 8443 ORC adaptor to the Occupant Restraint Controller
connector.
Measure the resistance of the Right Seat Belt Tensioner Line 1 circuit between the
SRS Load Tool ORC Adaptor connector and the Passenger SBT connector.
Is the resistance below 1.0 ohms ?All
Ye s®Go To 3
No®Repair open or high resistance in Passenger Seat Belt Tensioner
Line 1 circuit.
Perform AIRBAG VERIFICATION TEST - VER 1.
NOTE: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
3WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger SBT.
Disconnect the Occupant Restraint Controller connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the SRS Load Tool 8443 ORC adaptor to the Occupant Restraint Controller
connector.
Measure the resistance of the Passenger SBT Line 2 circuit between the SRS Load
Tool ORC Adaptor and the Passenger SBT connector.
Is the resistance below 1.0 ohms?All
Ye s®Go To 4
No®Repair open or high resistance in Passenger Seat Belt Tensioner
Line 2 circuit.
Perform AIRBAG VERIFICATION TEST - VER 1.
NOTE: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
4WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS DROPPED
AT ANY TIME, IT MUST BE REPLACED.
If there are no possible causes remaining, view repair.All
Repair
Replace the Occupant Restraint Controller (ORC) in accordance
with the Service information. WARNING: Make sure the battery
is disconnected and wait 2 minutes before proceeding.
Perform AIRBAG VERIFICATION TEST - VER 1.
NOTE: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
142
AIRBAG
ORC, PASSENGER SBT CIRCUIT OPEN - ACTIVE ÐContinued

Page 172 of 4284

CHRYSLER VOYAGER 2001 Service Manual Symptom:
ORC, PASSENGER SBT CIRCUIT SHORT - ACTIVE
When Monitored and Set Condition:
ORC, PASSENGER SBT CIRCUIT SHORT - ACTIVE
When Monitored: When the ignition is on, the ORC monitors the resistance

Page 173 of 4284

Page 174 of 4284

CHRYSLER VOYAGER 2001 Service Manual Symptom:
ORC, PASSENGER SBT SHORT TO BATTERY - ACTIVE
When Monitored and Set Condition:
ORC, PASSENGER SBT SHORT TO BATTERY - ACTIVE
When Monitored: When the ignition is on, the ORC monitors the volta

Page 175 of 4284

TEST ACTION APPLICABILITY
2WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger SBT.
Disconnect the Occupant Restraint Controller Connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the SRS load tool 8443 ORC adaptor to the Occupant Restraint Controller
connector.
WARNING: TURN IGNITION ON, THEN RECONNECT THE BATTERY.
Measure the voltage of the Passenger SBT Line 1 circuit between the Passenger SBT
connector and ground.
Is the voltage above 0.5 volts?All
Ye s®Repair the Passenger Seat Belt Tensioner Line 1 Short To
Battery.
Perform AIRBAG VERIFICATION TEST - VER 1.
No®Go To 3
NOTE: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
3WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Passenger SBT connector.
Disconnect the Occupant Restraint Controller connector.
NOTE: Check connectors - Clean and repair as necessary.
WARNING: TURN IGNITION ON, THEN RECONNECT THE BATTERY.
Measure the voltage between Passenger SBT Line 2 circuit between the Passenger
SBT connector and ground.
Is the voltage above 0.5 volts?All
Ye s®Repair the Passenger Seat Belt Tensioner Line 2 circuit for a
short to battery.
Perform AIRBAG VERIFICATION TEST - VER 1.
No®Go To 4
NOTE: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
4WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS DROPPED
AT ANY TIME, IT MUST BE REPLACED.
WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
If there are no possible causes remaining, view repair.All
Repair
Replace the Occupant Restraint Controller (ORC) in accordance
with the Service information. WARNING: Make sure the battery
is disconnected and wait 2 minutes before proceeding.
Perform AIRBAG VERIFICATION TEST - VER 1.
NOTE: When reconnecting airbag system components the Ignition must be
turned off and the Battery must be disconnected.
146
AIRBAG
ORC, PASSENGER SBT SHORT TO BATTERY - ACTIVE ÐContinued

Page 176 of 4284

CHRYSLER VOYAGER 2001 Service Manual Symptom:
ORC, PASSENGER SBT SHORT TO GROUND - ACTIVE
When Monitored and Set Condition:
ORC, PASSENGER SBT SHORT TO GROUND - ACTIVE
When Monitored: When the ignition is on, the ORC monitors the resista

Load next 8 pages

Page: < prev 1-10 ... 137-144 145-152 153-160 161-168 169-176 177-184 185-192 193-200 201-208 ... 4288 next >

lock stop start wheelbase fuel type maintenance schedule change language