2001 CHRYSLER VOYAGER Service Manual

radio controls rims radio antenna airbag disable height adjustment lumbar support

Page 913 of 4284

CHRYSLER VOYAGER 2001 Service Manual Symptom:
INCOMPLETE POWER OPEN - OVERCURRENT
When Monitored and Set Condition:
INCOMPLETE POWER OPEN - OVERCURRENT
When Monitored: Anytime the Power Sliding Door is in a power open operation.
Set Cond

Page 914 of 4284

CHRYSLER VOYAGER 2001 Service Manual TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Sliding Door Control Module C1 connector.
Using a 12-volt test light connected to 12-volts, check the Ground circuit.
Wiggle the harne

TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Sliding Door Control Module C1 connector.
Using a 12-volt test light connected to 12-volts, check the Ground circuit.
Wiggle the harness and check for an intermittent open condition.
Does the test light illuminate brightly?All
Ye s®Go To 4
No®Repair the Ground circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
4 Turn the ignition off.
Disconnect the Sliding Door Control Module C1 connector.
Measure the resistance between ground and the Sliding Door Open Driver circuit.
Wiggle the harness and check for an intermittent short circuit condition.
Is the resistance below 1000.0 ohms?All
Ye s®Repair the Sliding Door Open Driver circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No®Go To 5
5 Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Measure the resistance between the Cinch/Release Motor Latch Driver circuit and
the Cinch/Release Motor Unlatch Driver circuit.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 2.0 ohms?All
Ye s®Go To 6
No®Repair the Cinch/Release Motor Latch Driver circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
6 Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Measure the resistance between ground and the Cinch/Release Motor Latch Driver
circuit.
Wiggle the harness and check for an intermittent short condition.
Is the resistance below 100.0 ohms?All
Ye s®Repair the Cinch/Release Motor Latch Driver circuit for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
No®Go To 7
7 Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Measure the resistance between ground and the Door Motor Clutch Driver circuit.
Wiggle the harness and check for an intermittent short condition.
Is the resistance below 100.0 ohms?All
Ye s®Repair the Door Motor Clutch Driver circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No®Go To 8
8 If there are no possible causes remaining, view repair. All
Repair
Replace the Power Sliding Door Motor/Clutch assembly.
Perform BODY VERIFICATION TEST - VER 1.
885
POWER DOORS - SLIDING
INCOMPLETE POWER OPEN - OVERCURRENT ÐContinued

Page 915 of 4284

CHRYSLER VOYAGER 2001 Service Manual Symptom:
INCOMPLETE POWER OPEN - TIME OUT
When Monitored and Set Condition:
INCOMPLETE POWER OPEN - TIME OUT
When Monitored: Anytime the Power Sliding Door is operating in an opening operation.
Set Co

Page 916 of 4284

CHRYSLER VOYAGER 2001 Service Manual Symptom:
IOD WAKE UP OPEN - PSD
When Monitored and Set Condition:
IOD WAKE UP OPEN - PSD
When Monitored: Anytime the Body Control Module is awake.
Set Condition: If the BCM does not sense a signal cir

Page 917 of 4284

CHRYSLER VOYAGER 2001 Service Manual TEST ACTION APPLICABILITY
3 Disconnect the Body Control Module C3 connector.
Disconnect the appropriate Sliding Door Control Module C2 connector.
Measure the resistance of the appropriate Sliding Door

Page 918 of 4284

CHRYSLER VOYAGER 2001 Service Manual Symptom:
IOD WAKE UP PSD & PLG SHORT
When Monitored and Set Condition:
IOD WAKE UP PSD & PLG SHORT
When Monitored: Anytime the Body Control Module is awake.
Set Condition: If the BCM senses an over cu

Page 919 of 4284

CHRYSLER VOYAGER 2001 Service Manual TEST ACTION APPLICABILITY
3 Disconnect the Body Control Module C3 connector.
Disconnect the Left Sliding Door Control Module C2 connector.
Measure the voltage between the Left Sliding Door Wake Up Sig

Page 920 of 4284

CHRYSLER VOYAGER 2001 Service Manual Symptom:
LEFT B-PILLAR SWITCH INPUT OPEN
When Monitored and Set Condition:
LEFT B-PILLAR SWITCH INPUT OPEN
When Monitored: Continuously when the BCM is awake.
Set Condition: When the BCM senses an inp

Load next 8 pages

Page: < prev 1-10 ... 881-888 889-896 897-904 905-912 913-920 921-928 929-936 937-944 945-952 ... 4288 next >

battery capacity oil capacity maintenance schedule fog light bulb remote control ground clearance