2001 CHRYSLER VOYAGER Service Manual

Page 3873 of 4284

CHRYSLER VOYAGER 2001  Service Manual Symptom List:
P0133-1/1 O2 SENSOR SLOW RESPONSE
P0139-1/2 O2 SENSOR SLOW RESPONSE
Test Note: All symptoms listed above are diagnosed using the same tests.
The title for the tests will be P0133-1/1 O2

Page 3874 of 4284

CHRYSLER VOYAGER 2001  Service Manual TEST ACTION APPLICABILITY
2 Start the engine.
Inspect the exhaust system for leak between the engine and the O2 sensors.
Are there any exhaust leaks?All
Ye s®Repair or replace the leaking exhaust par

Page 3875 of 4284

CHRYSLER VOYAGER 2001  Service Manual TEST ACTION APPLICABILITY
6NOTE: Check for contaminates that may have damaged the O2 Sensor:
contaminated fuel, unapproved silicone, oil and coolant.
WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAN

Page 3876 of 4284

CHRYSLER VOYAGER 2001  Service Manual Symptom List:
P0134-1/1 O2 SENSOR STAYS AT CENTER
P0140-1/2 O2 SENSOR STAYS AT CENTER
Test Note: All symptoms listed above are diagnosed using the same tests.
The title for the tests will be P0134-1/1

Page 3877 of 4284

CHRYSLER VOYAGER 2001  Service Manual TEST ACTION APPLICABILITY
2 Turn the ignition off.
Disconnect the O2 Sensor harness connector.
Turn the ignition on.
Connect a test light to battery voltage, probe the O2 Sensor Signal circuit in the

Page 3878 of 4284

CHRYSLER VOYAGER 2001  Service Manual TEST ACTION APPLICABILITY
6NOTE: Ensure the voltmeter leads meet the terminals in the connector and
that there is good terminal to wire connection.
NOTE: Ensure the voltmeter leads are connected for p

Page 3879 of 4284

CHRYSLER VOYAGER 2001  Service Manual Symptom:
P0135-1/1 O2 SENSOR HEATER FAILURE
When Monitored and Set Condition:
P0135-1/1 O2 SENSOR HEATER FAILURE
When Monitored: During vehicle shutdown after vehicle had been driven greater than 10
m

Page 3880 of 4284

CHRYSLER VOYAGER 2001  Service Manual TEST ACTION APPLICABILITY
3NOTE: Allow the O2 sensor to cool down to room temperature.
Turn the ignition off.
Disconnect the O2 Sensor harness connector.
Measure the resistance across the O2 Sensor He