Page 945 of 4770
'99camry U
231
Replacing light bulbsÐ
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
Light bulbsBulb
No.WTy p e
HeadlightsHB260/55A
Parking, front side
marker and front
turn signal lights
Ð27/8B
Rear side marker
lights1943.8C
Rear turn signal
lights315627C
Stop and tail lights315727/8C
Tail light9049.3C
Back±up lights92118C
License plate lightsÐ5C
High mounted
stoplight21CP18C
Personal lightÐ10B
Interior lightÐ10D
Vanity lightsÐ3D
Glove box lightÐ1.2C
Trunk lightÐ3.8C
A: HB2 halogen bulbs
B: Single end bulbs
C: Wedge base bulbs
D: Double end bulbs
Page 946 of 4770
'99camry U
232
ÐHeadlights
1. Open the hood. Unplug the connec-
tor. Remove the rubber cover.
If the connector is tight, wiggle it.2. Release the bulb retaining spring
and remove the bulb. Install a new
bulb and the bulb retaining spring.
To install a bulb, align the tabs of the
bulb with the cutouts of the mounting
hole.3. Install the rubber cover with the
ºTOPº mark upward, and snuggle on
the boss. Insert the connector. Then
install the plastic cover.
Make sure the rubber cover fits snugly on
the connector and the headlight body.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
Page 947 of 4770
'99camry U
233
Use a flat±bladed screwdriver. Remove
and install the cover clips as shown in
the following illustrations.Removing cover clips
Installing cover clips
Use a flat±bladed screw driver. To protect
the surface, place several sheets of paper
over the surface.
ÐParking, front side marker
and front turn signal lights
Page 948 of 4770
'99camry U
234
a: Rear side marker light
b: Rear turn signal light
c: Stop and tail light
ÐRear side maker, rear turn
signal, stop and tail lights
Page 949 of 4770
'99camry U
235
a: Back±up light
b: Tail lightUse a flat±bladed screwdriver. Remove
and install the cover clips as shown in
the following illustrations.
ÐBack±up and tail lights
(type A)ÐBack±up and tail lights
(type B)
Page 950 of 4770
'99camry U
236
Removing the cover clips
Installing the cover clipsa: Back±up light
b: Tail light
Use a flat±bladed screwdriver. Remove
and install the cover clips as shown in
the following illustrations.
ÐLicense plate lights
Page 951 of 4770
'99camry U
237
Removing cover clips
Installing cover clips
ÐHigh mounted stoplight
Page 952 of 4770