2000 TOYOTA CAMRY Service Repair Manual

alternatorresetnight visiondashboard warning lightsrear entertainmenttrunk
Popular search:
p0401keylessbrake padsbrake sensorCam shaft pulleyCam bearing capweight
Previous
Next
Load previous 8 pages

Page 81 of 4770

TOYOTA CAMRY 2000 Service Repair Manual TIMING BELT COMPONENTS INSPECTION 1. INSPECT TIMING BELT NOTICE: wDo not bend, twist or turn the timing belt Inside out. wDo not allow the timing belt to come into contact with oil, water or steam. 22

Page 82 of 4770

TOYOTA CAMRY 2000 Service Repair Manual wDo not utilize timing belt tension when installing or removing the mounting bolt of the camshaft timing pulley. If there are any defects as shown in the illustration, check the following points: (a)

Page 83 of 4770

TOYOTA CAMRY 2000 Service Repair Manual 3. INSPECT TENSION SPRING (a) Measure the free length of tension spring. Free length: 46.0 mm (1.811 in.) If the free length is not as specified, replace the tension spring. (b) Measure the ten

Page 84 of 4770

TOYOTA CAMRY 2000 Service Repair Manual 4. TEMPORARILY INSTALL NO.1 IDLER PULLEY AND TENSION SPRING (a) Install the pulley with the bolt. Do not tighten the bolt yet. HINT: Use a bolt 42 mm (1.65 in.) in length. (b) Install the tension s

Page 85 of 4770

TOYOTA CAMRY 2000 Service Repair Manual 9. INSTALL CAMSHAFT TIMING PULLEY (a) Align the camshaft knock pin with the knock pin groove of the pulley, and slide on the timing pulley. (b) Using SST, install the plate washer and bolt. SST 09249

Page 86 of 4770

TOYOTA CAMRY 2000 Service Repair Manual 11. INSTALL TIMING BELT HINT. (When re±using timing belt): wCheck that the matchmark on the timing belt matches the end of the No.1 timing belt cover. If the matchmark does not align, shift the meshi

Page 87 of 4770

TOYOTA CAMRY 2000 Service Repair Manual 13. INSTALL NO.2 TIMING BELT COVER (a) Install the 2 gaskets to the No. 1 and No.2 belt covers. (b) install the belt cover with the 5 bolts. (c) Align the 2 clamps of the engine wire with cover mounti

Page 88 of 4770

TOYOTA CAMRY 2000 Service Repair Manual 17. INSTALL ENGINE MOVING CONTROL ROD (a) Temporarily install the engine moving control rod with the 3 bolts in the sequence shown. 15. INSTALL NO.2 ENGINE MOUNTING BRACKET (a) Temporarily install the
Load next 8 pages
Page:   < prev 1-10 ... 49-56 57-64 65-72 73-80 81-88 89-96 97-104 105-112 113-120 ... 4776 next >
lug patternspare tiretransmission fluidservice resetfuse box diagramgas type
Popular search:
fuse box locationWire diagramsRemoteHandle bezelengine mountmaintenanceradio antenna