2000 TOYOTA CAMRY Service Repair Manual

ad blue coolant reservoir tire type oil temperature start stop button torque

Load previous 8 pages

Page 2857 of 4770

TOYOTA CAMRY 2000 Service Repair Manual DI02D±01
Transaxle Control
System Check SheetInspector s
Name:
Customer s Name
Registration No.
Registration Year
Frame No.
Date Vehicle
Brought InOdometer Readingkm
mile / /
/

Page 2858 of 4770

TOYOTA CAMRY 2000 Service Repair Manual FI0534
DI02E±02
S05335
TOYOTA hand±held tester
DLC3
DI±438
± DIAGNOSTICSAUTOMATIC TRANSAXLE (A541E)
673 Author: Date:
PRE±CHECK
1. DIAGNOSIS SYSTEM
(a) Description
When troubleshooting OBD II

Page 2859 of 4770

TOYOTA CAMRY 2000 Service Repair Manual N09214
± DIAGNOSTICSAUTOMATIC TRANSAXLE (A541E)
DI±439
674 Author: Date:
The diagnosis system operates in normal mode
during normal vehicle use, and also has a check
mode for technicians to simu

Page 2860 of 4770

TOYOTA CAMRY 2000 Service Repair Manual FI0534
S05335
TOYOTA hand±held tester
DLC3
DI±440
± DIAGNOSTICSAUTOMATIC TRANSAXLE (A541E)
675 Author: Date:
2. INSPECT DIAGNOSIS (NORMAL MODE)
(a) Check the MIL.
(1) The MIL comes on when the ig

Page 2861 of 4770

TOYOTA CAMRY 2000 Service Repair Manual S05335
TOYOTA hand±held tester
DLC3
BR3904
ON
OFF0.13 sec.
0.13 sec.
± DIAGNOSTICSAUTOMATIC TRANSAXLE (A541E)
DI±441
676 Author: Date:
3. INSPECT DIAGNOSIS (CHECK MODE)
HINT:
TOYOTA hand±held te

Page 2862 of 4770

TOYOTA CAMRY 2000 Service Repair Manual DI±442
± DIAGNOSTICSAUTOMATIC TRANSAXLE (A541E)
677 Author: Date:
(b) Clearance the DTC.
The following actions will erase the DTC and freezed
frame data. Operating an OBD II scan tool (complying
w

DI±442
± DIAGNOSTICSAUTOMATIC TRANSAXLE (A541E)
677 Author: Date:
(b) Clearance the DTC.
The following actions will erase the DTC and freezed
frame data. Operating an OBD II scan tool (complying
with SAE J1978) or TOYOTA hand±held tester to erase
the codes.
(See the OBD II scan tool's instruction book for operating
instructions.)
4. ROAD TEST
NOTICE:
Perform the test at normal operating ATF temperature 50 ± 80 °C (122 ± 176 °F).
(a) D POSITION TEST
Shift into the D position and fully depress the accelerator pedal and and check the following points:
(1) Check up±shift operation.
1 " 2, 2 " 3 and 3 " O/D up±shift takes place, at the shift point shown in the automatic shift
schedule (See page SS±56).
HINT:
O/D Gear Up±shift Prohibition Control (1. Coolant temp. is 60 °C (140 °F) or less. 2. If there is a 10
km/h (6 mph) difference between the set cruise control speed and vehicle speed.)
O/D Gear Lock±up Prohibition Control (1. Brake pedal is depressed. 2. Coolant temp. is 60 °C
(140 °F) or less.)
(2) Check for shift shock and slip.
Check for shock and slip at the 1 " 2, 2 " 3 and 3 " O/D up±shifts.
(3) Check for abnormal noises and vibration.
Run at the D position lock±up or O/D gear and check for abnormal noises and vibration.
HINT:
The check for the cause of abnormal noises and vibration must be done very thoroughly as it could also be
due to loss of balance in the differential torque converter clutch, etc..
(4) Check kick±down operation.
While running in the D position, 2nd, 3rd and O/D gears, check to see that the possible kick±down
vehicle speed limits for 2 " 1, 3 " 2 and O/D " 3 kick±downs conform to those indicated on
the automatic shift schedule (See page SS±56).
(5) Check abnormal shock and slip at kick±down.
(6) Check the lock±up mechanism.
Drive in D position, O/D gear, at a steady speed (lock±up ON) of about 60 km/h (37 mph).
Lightly depress the accelerator pedal and check that the engine speed does not change
abruptly.
If there is a big jump in engine speed, there is no lock±up.
(b) 2 POSITION TEST
Shift into the 2 position and fully depress the accelerator pedal and check the following points:
(1) Check up±shift operation.
Check to see that the 1 " 2 up±shift takes place and that the shift point conforms to the automatic
shift schedule (See page SS±56).
HINT:
There is no O/D up±shift and lock±up in the 2 position.
(2) Check engine braking.
While running in the 2 position and 2nd gear, release the accelerator pedal and check the engine
braking effect.
(3) Check for abnormal noises during acceleration and deceleration, and for shock at up±shift and
down±shift.

Page 2863 of 4770

TOYOTA CAMRY 2000 Service Repair Manual Q00519
AT3417
OK if hot
Add if hot
± DIAGNOSTICSAUTOMATIC TRANSAXLE (A541E)
DI±443
678 Author: Date:
(c) L POSITION TEST
Shift into the 2 position and fully depress the accelerator pedal and check

Page 2864 of 4770

TOYOTA CAMRY 2000 Service Repair Manual AT4657
AT8562
AT3417
OK if hot
Add if hot
AT4252
0 ~ 1 mm (0 ~ 0.04 in.) DI±444
± DIAGNOSTICSAUTOMATIC TRANSAXLE (A541E)
679 Author: Date:
(c) Replace the ATF.
(1) Remove the drain plug and drain

Load next 8 pages

Page: < prev 1-10 ... 2825-2832 2833-2840 2841-2848 2849-2856 2857-2864 2865-2872 2873-2880 2881-2888 2889-2896 ... 4776 next >

radio controls window trunk release suspension change wheel fuel tank capacity