2006 ACURA CSX Service Repair Manual

timing belt fuse seat memory maintenance reset technical specifications

Page 2089 of 2893

ACURA CSX 2006 Service Repair Manual
(#)
(#
)
22-14122-141
Trunk Lid Release Actuator Test Hood Switch Test
1. Open the trunk lid.
2. D

Page 2090 of 2893

ACURA CSX 2006 Service Repair Manual

(#

)
With HDS
22-142 Keyless/Power Door Locks/Security System
Transmitter Test/Replacement
A
NOTE:
If the doors unlock or lock with the transm

(#'

)
With HDS
22-142 Keyless/Power Door Locks/Security System
Transmitter Test/Replacement
A
NOTE:
If the doors unlock or lock with the transmitter, but the LED on the transmitter does not come on, the LED
is faulty; replace the transmitter.
If any door is open, you cannot lock the doors with the transmitter.
If you unlocked the doors with the transmitter, but do not open any of the doors within 30 seconds, the
doors relock automatically.
The doors do not lock or unlock with the transmitter if the ignition key is inserted in the ignition switch.
1. Press the lock or unlock button five or six times to reset the transmitter.
If the locks work, the transmitter is OK.
If any of the transmitter buttons do not work, replace the transmitter, then do the transmitter
programming registration (see page 22-329).
If the locks don’t work, go to step 2.
2. Connect the HDS to the data link connector.
3. Select the KEYLESS from the BODY ELECTRICAL menu, then enter the KEYLESS CHECK.
4. Press lock, unlock, trunk, or panic button and check the response on the screen of the HDS.
NOTE: The door lock actuators may or may not
cycle when receiving input from the transmitter.
If KEYLESS ENTRY TRANSMITTER CODE IS RECEIVED is indicated, the transmitter is OK. Go
to keyless operation troubleshooting (see page
22-127).
If DIFFERENT KEYLESS ENTRY TRANSMITTER CODE IS RECEIVED is indicated, the transmitter is
not registered to the vehicle, if necessary,
reprogram and register the transmitter (see page
22-329).
If KEYLESS ENTRY TRANSMITTER CODE IS NOT RECEIVED is indicated, go to step 5. 5. Open the transmitter and check for water damage.
If you find any water damage, replace thetransmitter, then reprogram and register the
transmitter (see page 22-329).
If there is no water damage, go to step 6.
6. Replace the transmitter battery (A) with a new one, and press lock or unlock button and check the
receive condition on the screen of the HDS.
If KEYLESS ENTRY TRANSMITTER CODE IS RECEIVED is indicated, the transmitter is OK.
If KEYLESS ENTRY TRANSMITTER CODE IS NOT RECEIVED is indicated, go to step 7.
08/08/21 14:26:07 61SNR030_220_0144
ProCarManuals.com
DYNOMITE -2009-

Page 2091 of 2893

ACURA CSX 2006 Service Repair Manual
Without HDS
22-143
7. Use a different known-good keyless transmitterand repeat steps 3 and 4.
NOTE: The keyless transmitter does not need to be
programmed to the vehicle for this test.
If (DIFF

Page 2092 of 2893

ACURA CSX 2006 Service Repair Manual
22-144Keyless/Power Door Locks/Security System
Transmitter Test/Replacement (cont’d)
A
4. Replace the transmitter battery (A) with a new one,
and try to lock and unlock the doors with the
trans

Page 2093 of 2893

ACURA CSX 2006 Service Repair Manual Î
(#)

22-145
Horns
Component Location Index
HORN SWITCH
CABLE REEL
HORN RELAY CIRCUIT
(Built into the MICU)
HORN
UNDER-DASH FUSE/RELAY BOX Test, pag

Page 2094 of 2893

ACURA CSX 2006 Service Repair Manual Î
(#)

(#
)
22-14622-146 Horns
Circuit Diagram
Horn Test/Replacement
F31 G16
G7
Q3
HORN
* : G

Page 2095 of 2893

ACURA CSX 2006 Service Repair Manual Î

(#

)

22-147
Horn Switch Test
A A
B
C
1. Remove the steering column covers (see page
17-9).
2. Disconnect the cable reel 20P connector (A) from

Page 2096 of 2893

ACURA CSX 2006 Service Repair Manual Î
Î(#
)
22-148Exterior Lights
Component Location Index
DAYTIME RUNNING LIGHTS CIRCUIT
(Built into the MICU)
HEADLIGHT
FRONTSIDEMARKERLIGHT
FRO

Load next 8 pages

Page: < prev 1-10 ... 2057-2064 2065-2072 2073-2080 2081-2088 2089-2096 2097-2104 2105-2112 2113-2120 2121-2128 ... 2896 next >

ESP manual radio set towing capacity child lock seat memory maintenance